Hi All,
i'm new on the site - first post. Been reading a few threads and am amazed at the knowledge out here. So I have a late 1950 8n (my first tractor) and I'm in the throws of rebuilding it. I discovered the front axle bearings were shot, as well as the spindle bushings and thrust bearings (both sides). I assume the kingpin bushing is in the same condition, but I can't find anywhere how to test it. I have the FO-4 Manual and it describes how to change it, but doesn't say how to test it. Anybody know? With the front end off the ground, I can move the axle up and down a bit - so is this play normal or is the Kingpin bushing worn?
i'm new on the site - first post. Been reading a few threads and am amazed at the knowledge out here. So I have a late 1950 8n (my first tractor) and I'm in the throws of rebuilding it. I discovered the front axle bearings were shot, as well as the spindle bushings and thrust bearings (both sides). I assume the kingpin bushing is in the same condition, but I can't find anywhere how to test it. I have the FO-4 Manual and it describes how to change it, but doesn't say how to test it. Anybody know? With the front end off the ground, I can move the axle up and down a bit - so is this play normal or is the Kingpin bushing worn?
