812 Front end loader leveling ?? on a 5252

[Dupa]

Hello, new owner to a 5252 with a 812 front end loader. It is not level by about 1" to 1 1/2 ". I don't know how to level it using the hydrolics???

Any advice would be appreciated.

Thanks

 

[7254t]

check rear tire pressure.

 

[Dupa]

Not the rear tire pressure or any pressure problem, I am checking the bolts for tightness next, No visually obvious bends in the frames. Moving on.. must adapt

 

[Mike5252]

If its not the tires, might be a sprung loader frame. I think that's pretty much impossible to fix.

 

[NassauEquipment]

Like mentioned,tire pressure FRONT and rear. If ok , sounds like the loader mounts are off some.measure from lower side of each mount to a flat surface. There is some "Play" in the holes of most loader mounts....as you move to the leading edge of the bucket......a little difference at the mounts becomes alot.

 

[longie33]

what happens if tractor on level surface -loosen mount screws-apply down pressure on bucket-tighten mount screws!!!