Bus mech
New member
Trying to rebuild bucket dump cylinder but can't get nut to come off of end of cylinder. Nut just turns. No wire or cable on cylinder any suggestions?
7108 loader
- Thread starter Bus mech
- Start date
- Views: 7662
TraderMark
Gold Member
- Joined
- Feb 25, 2001
- Messages
- 383
- Location
- Southeast Georgia
- Tractor
- Ford 1720, 2910 John Deere 970, Case 1845
Bus Mech,
Welcome to the forum first of all!
The nut on my 7108 bucket cylinders was a very thin nut with a couple slots in it. The gland had two flat spots on it. I had to hold the gland by the flat spots to keep it from turning, then screw the nut off. Once I had the nut off, I had to push the gland deeper into the cylinder and remove a round wire snap ring. Once I had the snap ring out, I could pull the rod/piston/gland assy out.
Hope this helps.
Mark
Welcome to the forum first of all!
The nut on my 7108 bucket cylinders was a very thin nut with a couple slots in it. The gland had two flat spots on it. I had to hold the gland by the flat spots to keep it from turning, then screw the nut off. Once I had the nut off, I had to push the gland deeper into the cylinder and remove a round wire snap ring. Once I had the snap ring out, I could pull the rod/piston/gland assy out.
Hope this helps.
Mark
Here are some similar links:
