5v steel roofing
- Thread starter randy41
- Start date
- Views: 925
hosspuller
Veteran Member
- Joined
- Oct 9, 2008
- Messages
- 1,787
- Location
- Piedmont Triad, NC
- Tractor
- Didn't intend to have a Deere fleet - it just happened 310C, F915,102, 5200 & 5065E
The v's will hold the metal away from the supporting boards.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
yup... might be ok on a roof over a bale of hay or something... but i wouldn't do it on a barn.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
sure.. you CAN screy it down.. it just won't set flat on the purloins and runners.. it therefore may not seal end to end, and may rattle in the wind.. etc. if it is a single long piece for the runs.. may make less of a difference.. especially if it is just a top cover, open sided structure on the cheap.
Dr Dave
Platinum Member
I have seen commercial buildings done this way, but only on the walls. This was 26 guage steel.
Dave
Dave
Here are some similar links:
