Smokeonthewater
Silver Member
- Joined
- Apr 29, 2021
- Messages
- 122
- Tractor
- 2010d
...
Last edited:
...
- Thread starter Smokeonthewater
- Start date
- Views: 865
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
That is a flogged out shredder you have there. I bet the spindles come out the top that collar is probably rust seized on the shaft. Remove the corroded hex bolts and remove the spindles (after removing the blades of course).
It's pulley btw.
It's pulley btw.
oldnslo
Super Member
On some mowers The spindle will pull out the top once the blade mount is removed. Hopefully you can tell if you can get the blade mounts off. I suspect there will be a little rust involved 
Fuddyduddy1952
Super Member
- Joined
- Aug 10, 2022
- Messages
- 8,787
- Tractor
- john deere
To me, and take this with a grain of salt, it looks like it's seen better days and I'd make a decision before doing anything. In other words if it's functional as-is what's it worth (if sold). If you keep it, how is it going to be used? If I were to keep it, it's all or nothing. I'd remove & replace all three spindles. While apart I'd have it sandblasted, weld plates where spindles are drilled for new spindles. Prime & paint.
I'm thinking over the years it's been patched & welded and to use based on use like a bush hog or finish mower would determine what spindles & blades I'd install.
I'm thinking over the years it's been patched & welded and to use based on use like a bush hog or finish mower would determine what spindles & blades I'd install.
