Backhoe 50 hour service on MF 1710 TLB

[67gtoowner2]

Do I need to remove the backhoe attachment before replacing the hydraulic fluid in the tractor or should I leave it attached?

 

[Dmacleo]

yes remove it.

 

[LS Tractor Owner]

It won't matter..... unless it is in the way of working on it. No fluid will come out of the BH.

 

[Dmacleo]

You can't accurately see sight glass when it's mounted. Getting at fill tube a pain with it on also.

 

[67gtoowner2]

Thanks for the input, I plan to remove it for access to the fill tube and sight glass. It is an easy task to remove the backhoe.

 

[67gtoowner2]

Another question:

Do I check the sight glass with tractor idling or not running?

 

[irvingj]

Idling, on a level surface. If the sight glass is totally full, you probably won't be able to tell if it's empty or full; you might look at it first with the engine NOT running (it will be a bit lower) to see if you can see the fluid line in the sight glass. Then start and look again. Better yet, stand back there looking while someone else starts the engine.

 

[67gtoowner2]

Thanks fopr the response

 

[ray66v]

The reason the transmission has a big sight glass, and not a dip stick is the oil level isn't real critical. If it's anywhere in, or close to the sight glass, it's going to work fine.

It can be hard to tell where you're at, especially if you fill it above the sight glass. So, take your time with the last gallon.

 

[WranglerX]

One can always put a dye in fluid to better indicate fluid level in sight glass...