The current thread on hydraulic valve options shows a nice arrangement for the 4100 with power beyond mounted on the lower ROPS. That location would also work for the extra valves. It is nice have the lines centered but you can always route them that way. This is probably more important if you are in brush doing clearing work. I had the dealer install my setup so I've not paid much attention to routing details. They've been pretty knowledgable about it and always welcome me to discuss any concerns.
4th & 5th SCV
- Thread starter DDT
- Start date
- Views: 4005
sniezur
Bronze Member
sniezur
Bronze Member
OP
DDT
Platinum Member
- Joined
- Dec 18, 2000
- Messages
- 953
- Location
- Clay Center, Kansas
- Tractor
- Kubota M6040/cab, BX25D, RTVX900
sniezur
Thanks for the pic's. I see yours is all above the top link, that is a better location than mine.
DDT
Thanks for the pic's. I see yours is all above the top link, that is a better location than mine.
DDT
DDT, I have the same setup as sniezur's. The fourth and fifth are slightly further to the rear of the tractor compared to the plate for the power beyond and 3rd. You can see that in his pictures if you look closely. I just got my tractor returned this afternoon and haven't taken pictures yet. If you need more let me know.
OP
DDT
Platinum Member
- Joined
- Dec 18, 2000
- Messages
- 953
- Location
- Clay Center, Kansas
- Tractor
- Kubota M6040/cab, BX25D, RTVX900
Just a up date- My loacl dealer is tryeing to find away to move the (yellow ended) couplers to the roll bar. I had to drill post holes tonight, guess what The digger would not fit the tractor, it hit the couplers next to the top link.
discouraged in kansas!!!
discouraged in kansas!!!
