3720 open station 3ph lever getting loose

[fishhead]

my lift lever has loosened up and will no longer stay back. My understanding is that i should try to tighten the nut on the end of the shaft and if that doesn't work then the friction washers need replacement. On the GTT forum a poster was saying i need to remove the wheel and fender- does anyone know if that can be avoided and how best to access?

Thanks

 

[beenthere]

Removing likely offers better access so makes the task easier. Not a major job to remove. Just go slowly and carefully.

 

[fishhead]

Thanks

 

[Harry in Ky]

I see a friction washer listed (item 1) but I don't see any nut to adjust that will tighten it. Looks like spring washers (item 11) probably provide the tension.

https://partscatalog.deere.com/jdrc/sidebyside/equipment/3584/referrer/navigation/pgId/2693876

 

[oldtimer 66]

I see a friction washer listed (item 1) but I don't see any nut to adjust that will tighten it. Looks like spring washers (item 11) probably provide the tension.

https://partscatalog.deere.com/jdrc/sidebyside/equipment/3584/referrer/navigation/pgId/2693876

Maybe Pt 9 threaded onto Pt 30?