$35 Debris Forks

[2515R Dude]

Tried my welding skills (not so good, haven't been welding for more than 45 years).
But eventually it worked, i'm happy with the result.
Got it right on the second try. On the first one of the cross bars got bent. Removed them and it seemed to work better.

 

[airbiscuit]

Nice. They are handy. Here.s what I did with scrap angle iron and my forks.

 

[WranglerX]

I did something similar... But there is large angle iron across back of forks that allow me to remove a bolt (pin) on each side to remove forks when not needed...

 

[Vigo327]

^ I like the simplicity of that approach!

 

[scootr]

I went with a claw for an old set of forks

 

[Tinhack]

I went with a claw for an old set of forks

I've got forks and I've got a grapple. There's been more than a few times I've had to run back to shed to change them out. That setup looks like it would work for me. Maybe I just need a bigger tractor.

 

[GeneV]

I went with a claw for an old set of forks

Nice! If I could justify a grapple, that would be my setup too.

 

[GeneV]

Here's mine I diy'ed, using steel from the steel crate my mower shipped in:

 

[California]

Here's mine I diy'ed, using steel from the steel crate my mower shipped in.

Great pix, and a beautiful site.

 

[GeneV]

Great pix, and a beautiful site.

Oh thx man!

 

[2515R Dude]

I went with a claw for an old set of forks

For $35?

 

[scootr]

For $35?

No - A little more I'm afraid. But the forks were free which was the inspiration