topsaiilbye
New member
just had first snowfall. Currently getting a little rubber aroma from drive belt in heavy snow. too tight or too loose? how tight should I adjust. Thoughts?
325 Snowlower Drive Belt Tension
- Thread starter topsaiilbye
- Start date
- Views: 820
Richard001
Veteran Member
Can you give us the model number of the blower?
Richard
Richard
OP
topsaiilbye
New member
can't find Model # , it the JD 42 inch, single stage snowthrower.
jaydee325
Veteran Member
- Joined
- May 21, 2013
- Messages
- 1,204
- Location
- Casco, Mi
- Tractor
- John Deere X584 Garden Tractor & LS R3039H
I had a 42 snow thrower on a Deere 325. Had the same thing happened and it was the belt that drives the auger on the blower (vice the belt from the tractor to the auger drive shaft).
I pulled the cover and found the area full of grease from greasing the drive shaft. I cleaned the whole housing out and put a new belt on it. Never slipped again.
Do you have the owners manual for the thrower? If not, check Deere publications for a down load.
I pulled the cover and found the area full of grease from greasing the drive shaft. I cleaned the whole housing out and put a new belt on it. Never slipped again.
Do you have the owners manual for the thrower? If not, check Deere publications for a down load.
Richard001
Veteran Member
Without the model number, it is hard to look up the user manual.
Can you post a few photos of the unit?
How is the main drive belt tightened?
Richard
