Have a 3016hst using it the other day getting garden ready was running fine went and put fuel in it and shut off, once done fueling went to start and acted like battery was dead, tested battery and it was on the weaker side so replaced with new, still the same thing maybe crank one or 2 revolutions then just stuck acting, took starter off and found it was on last leg as well, so bought a new starter tried to spin over once normal and then back to barely cranking at all install new cables as well. At a loss can a bad hydraulic pump be my issue acts like the starter is under a major load?
doneill127
Gold Member
I’d check battery cables/clamps. I had to replace the positive cable and clamp because of corrosion inside the cable on a similar machine. Also when the battery is out might want to disconnect the ground wire to battery tray/frame connection and clean it up with a wire brush or emery cloth,
Molalla1
Elite Member
Molalla1
Elite Member
doneill, he replaced the cables . . .
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 3,367
- Location
- Eating a melon..
- Tractor
- Mahindra 5010C- Branson 4520r- 5520C- Yanmar FX235-D - Bad Boy rogue mower
Is the pto off
Is Transmission in neutral
Is the clutch pedal button solenoid out of adjustment ?
How about where the cable connects to the starter.
Did the starter come with a new solenoid??
How about an update?
Is Transmission in neutral
Is the clutch pedal button solenoid out of adjustment ?
How about where the cable connects to the starter.
Did the starter come with a new solenoid??
How about an update?
Last edited:
