300x Loader stuck in bound cockeyed position

[ChristopherHawkins]

I just finished and everything is fine. Hurray!!!

Dirt had the answer. I removed the male ends from the quick disconnect hoses. This relieved the pressure. I then took a spud bar and levered the loader up using the mast as the fulcrum. By jockeying it around a bit more everything fell into place.

Thanks to Dirt and all who provided suggestions.

 

[kennyd]

I just finished and everything is fine. Hurray!!!

Dirt had the answer. I removed the male ends from the quick disconnect hoses. This relieved the pressure. I then took a spud bar and levered the loader up using the mast as the fulcrum. By jockeying it around a bit more everything fell into place.

Thanks to Dirt and all who provided suggestions.

Great news Just remember my advice next time you want to remove it!

 

[dirtworksequip]

Chris, I was beginning to wonder how things were going for you? Glad you got it all worked out and back to where it needed to be.

Sincerely, Dirt

 

[pat32rf]

I had forgot (gettin old) that he had the left side attached already. Few things are more frustrating than being able to see where something has to go but not being able to move it there......Glad you are back in the saddle

 

[ChristopherHawkins]

I got hung up in other work and couldn't get to it until today. It sure was nice when I started it up and didn't have any leaks and the loader was sitting properly aligned.

 

[Nuru]

Good job Chris and good posts by everyone else too.