300 CX QA mounts

[foggy1111]

I own a 300CX loader with JD QA mounts. I want to build a FEL Snow Plow and just bought the hooks and pins from JD. I also recently bought an old Meyer #ST80 truck plow and I'm anxious to get started on this project.

I live about 200 miles from my tractor so getting dimensions from my tractor is difficult. I would like to fab the new frame with JD hardware and tack-weld it together here at home. Then I could bring my new frame and snow plow to a welding shop near my land for tweaking and final welding (and save a few bucks and get the end result I want :thumbsup.

One problem is that I do not have the "layout" dimensions for the JD QA loader mounts. I was unable to turn 'em up with a search. Does anyone have a "schematic" with the QA measurements? It would be a big time saver for me.

Thanks in advance!

 

[foggy1111]

Lots more searching here on TBN led me to a build-it-yourself shrub bucket build for a JD 300 loader....where I got the needed information.

That shrub bucket is a very nice project too! :thumbsup: ....but it will need to go on the "back burner".