3 point problem

[thomp86540]

MF 35 industrial, 3 point only goes all the way up or down can not adjust, trying to use a box scrapper for clean up.

 

[Jerry/MT]

MF 35 industrial, 3 point only goes all the way up or down can not adjust, trying to use a box scrapper for clean up.

You should have a means of selecting position control on the three point. Look closely at the quadrant. Most tractors have two levers; one for draft control and the other for position control. I'm not sure what the MF35 uses.

 

[thomp86540]

You should have a means of selecting position control on the three point. Look closely at the quadrant. Most tractors have two levers; one for draft control and the other for position control. I'm not sure what the MF35 uses.

This tractor has a lever for draft control and another for oeprating the 3 point, The problem is the 3 point is either all the way up or at the bottom no control between. totally confused!

 

[pjbci]

Which lever are you using? The inside is your position, the outside lever is draft. Using the wrong lever will cause it to act this way.