1998 kioti 3054 adding loader

[reelnative]

this is a first to me so im going to need some help, I have a westendoft ta25 loader to install on the kioti 3054 but dont know how much flo or psi this tractor has, also I dont know if this loader is too big for the tractor eather, also what type of control will I need as the laoder doesnt come with one, the loader has 2.5in dia rams, thanks for any help

 

[J_J]

Open center, 7 GPM

http://www.surpluscenter.com/item.asp?item=9-7401&catname=hydraulic

 

[reelnative]

thanks JJ could you tell me what open center is I dont have a clue, and does this tractor put out 7gpm or is that what im gonna need thanks

 

[J_J]

That means that there is no pressure in the system until a valve is activated, although the pump is running. Also, all the valves are in series.

The specs say 7 GPM valve flow, which is the volume at max pump speed. The volume of fluid will determine the cyl speed, or the speed of a hyd motor.

 

[reelnative]

Thanks again JJ you are a welth on knowledge, would you happen to know what the psi its running and do you think 7gpm is enough to run a loader or should I say power the loader good enough Thanks again

 

[J_J]

Total pump flow is 10 GPM. so about 3 would go to the power steering. Psi should be around 2300 to 2500. Check the manual for your specs.