1958 Case model 320 backhoe

[bgarrison54]

I need the hydraulic cylinder for the bucket on a 1958 Case 320. 4" x 32 " I think. Does anyone know of any ? Thanks, Bob Garrison

 

[dex3361]

Have you tried Surplus Center
Burden Sales Surplus Center

 

[Wayne County Hose]

I need the hydraulic cylinder for the bucket on a 1958 Case 320. 4" x 32 " I think. Does anyone know of any ? Thanks, Bob Garrison

Hello Bob and welcome to TBN.

Here is your best bet. You need to measure the stroke of your cylinder. Then, make your best guestimate as to the bore. Measure the OD of the cylinder and subtract about a quarter inch, close enough. Find a new cylinder close to this, maybe you will find one with the proper ends. Probably not. What you can do is have your ends cut off the old cylinder and welded on the new one. Hopefully, your old cylinder is nothing fancy. If you go that route, take it to a good shop to have it done, not some nutjob with a welder and a 30 pack in the fridge next to it.

Andy

 

[kennyd]

take it to a good shop to have it done, not some nutjob with a welder and a 30 pack in the fridge next to it.

Andy

Guess that lets me off the hook then

Bgarrison: What is wrong with the cylinder you have?