wont start

Massey 1260 I just got finished changing the hydraulic fluid and filter on the rear end. Cranked it up and it started then died and won't restart, like low oil pressure . No lights are on. That is if they work. Is there a special way to prime after a hydraulic change? There is a fill port...

Tractor started hard a few times. Changes the fuel filter abd it fired right up. This a.m., same thing. Checked wires and fuses. Cranked but no fire. 1/4 squirt of ether and fired instantly. Got out in the woods and she just quit. Cranks, but no go. How do I tell if the fuel solenoid is...

My Branson 2810 runs great, all the gauges and sensors are appear to work properly, no lights or indicators. However after I run it for about 30 minutes it refuses to start until I let it sit for about 30-40 minutes. When I turn the ignition it just turns over and over with no sign of it even...

OK gents, I have to do this, been reading through the posts and do not have the time to read a bazillion threads. SO, Going to my lower pasture Sunday, hit a ground hog hole, triggered the seat switch, engine stopped. USUALLY, it fires right back up with a momentary overheat warning but then...

I need help on possible things to look at on a Ford 1110 that was running before an oil and hydraulic change but now will not start. Here is a little backstory and details: I just bought a 1985 Ford 1110 with the HST with 1083 hrs on it. It was running and decent but not great starting in the...

I have a 455 serial number is 70131. While mowing it died on me. The battery is weak but strong enough to run the mower once boosted off. I got my jump box and started the mower but the fuel solenoid hold back didn't work. I was almost done mowing so I tried tying the solenoid back. It...

Hi all, new to the forums. Forgive me if this question has been asked... I could not find it with the search feature. Just picked up a used B2400HSD yesterday. I believe it's pre-'97 so must be a '95 or 96'. 1200 hours, super clean machine. Was owned by an elderly man that bought it new...

I was mowing the yard, got off the mower to pick something up and it died (have never had this issue before). The only way we got it to start was to jump the solenoid while someone was sitting on it, which it stays running but will not move. It won't go forward or backwards. Park brake is off...

Hello newbie to the forum here. I did search first but could not locate a post related to my issue. A buddy referred me to this site. The issue is I'm getting no power to the EIM and the front and rear lights do not light, I could turn them on with a switch even with the power off. What...

So I stopped my mahindra 4550 and out it in neutral and turned it off. Got back in a few minutes later and nothing. No dash lights and doesn't try to crank. I verified it was in neutral and still nothing. Check voltage and fuse panel and had 13v. Checked voltage going to ignition and...

I got this Tractor as a barn find only 85 hours. It hasn’t been turned on in years. When I go to turn it on all it does is crank. I emptied all the fuel out of it and replaced it with new. Still does the same thing. All the fluids are full. I pulled off the injector lines and they had fuel but...

Good evening, I have a Kubota G1800 tractor. This Kubota would intermittently not start. The bendix would hit the flywheel without engaging. First, I bought a brand new Chinese starter. (Smart right?) That didn't work so I tried shimming it. I read online that you can put a starter relay into...