turn

I am wondering if a Zero Turn, such as a Ferris with suspension, would be a better faster smoother more comfortable mower for my pastures? All I see in promotional videos are using these for lawns, not pastures. But if a speedy ZTR could perform well, I might be more comfortable (suspension)...

So for my small JD compact tractor I need some kind of small pouch or tool box that can be accessed while in the seat. Doesn't have to be huge but large enough to hold a few small tools, something that can be mounted to the tractor. I've looked at every small bag/pouch I have, even wandered...

Hello everyone, I have a Troy bilt horse pto with the Kohler magnum 8 and electric start. Recently after washing it I noticed that it starts up fine, but when the key is turned to the off position the engine does not shut off. I bought a replacement ignition switch with the correct 3 poles and...

I have a brake switch bad on my zg222. In a very difficult place to get to. Anyone changed one that might have a tip to make it doable without disassembling the front of my mower. Looks like removing the deck isn’t going to help a lot. Any way thanks for reading

Next up after getting the old girl running is to try to figure out why the flashers and turn signals don't work. TC34DA. head lights work but no flashers or turn signals ... I did find a "brick" inside the dash with lots of functions listed... to replace that is...

I have a T254 about 11 years old, 516 hours. I have this intermittent no start problem in cold temperatures below 10°F. Turn the key to preheat and the relay will click, light on the dash comes on, 10 seconds later you can hear the relay click again, light goes off. Turn the key to start and...

I haven't been on this forum in years. My last tractor was one of those grey import Vietnamese used Yanmar units. I loved that thing and used it well on my one acre dirt property in Mesa AZ. I had sold it 10 years ago for a bobcat MT85 skid steer since I mainly used it for trenching and...

I just bought a used RC100 with an unknown amount of hours as the display seems inoperative. But that isn't my issue. When cold the RC100 acts mostly as it should although turning is jerky and fast sometimes and slow others. However, when warmed up you pretty much have to stop moving to turn...

When I was a kid helping out is a shop, the meticulous owner told me to ALWAYS turn the lights on for two minutes before a battery charge to drain off surface resistance to a charge. Is this a wive's tale?

So the turn signal flasher relay just suddenly failed in my RTV-X1100C. When I turn a signal or 4-ways on, all four exterior and the dash indicators stay on solid. Kubota wants $200 for this relay here in northern Ontario, so I bought a whole new complete signal kit for $300 instead as dumb as...

It seems like common advice, buy a zero turn for mowing the lawn, mid mount mowers are awful, use the tractor for tractor stuff. My JD 2025r is under the bellcrank recall and mine is cracked so it’s a no go. I normally mow with it, a 60” mid mount. I borrowed a friends zero turn Scag, a...

Hi, I have a new to me BX 25 in nice shape, all the lights work except for the Hazard/Blinkers. They flash on the dash but not at the light. When I have the head light on all four bulbs in the back orange housing light up but nothing flashes, If the lights are off they don't flash either or...

I currently have a Ferris IS 3200Z with a 72" cut side discharge and over the last year it has been very unreliable, something triggers a safety on the Brigs Engine it has under 200 hours. The engine shuts down after maximum of 45 minutes and sometimes just a few minutes, you have to get off...

I have an NX5010 and have wiped out 3 flasher / turn indicators on trees while mowing. I found some aftermarket protection / shields but they are a little pricey for just some sheet metal. So, I hacked my own protection and haven't lost a light since. See the attached photo below. What I did was...

Countyline 6ft tiller about 5 years old, gets used about 4 hours per year. Hooked up to tiller turned on pto. tiller tines turned for about 10 minutes in field then stopped turning. Usually the slip clutch and a rock are involved. Not this time, slip clutch works fine, output shaft from pto...

The bigger my implements get, the harder it becomes to line up the splines on the pto shaft at hookup. I've taken to setting my tiller up on blocks so that I can turn the tines with my foot and gradually rotate the pto shaft for alignment. I was unaware that you could simply turn the splines on...

I bought this mower about 3 years ago and it was my first Z turn and really my first riding mower purchase of any sort. I think it was about $4000. I got this particular model for the specs, price and availability at a local dealer/repair shop. It is one step above their base homeowner lineup...

Replaced a very worn pto belt and the PTO was disengaging fine before belt replacement. Now the PTO does not disengage which in turn the blades keep turning. There is a belt tensioner pulley thinking I might be able to adjust that. Ideas anyone? Thanks

2001 Scotts S2554 clicks from the on-starter solenoid but rarely turns over. It has had this problem from very early on, charge lights always stay on while running too. I changed the voltage sensor dongle a long time ago but that didn't solve the charge lights problem. So normally you need to...

Hello. A zero turn came with the home we bought last year and I’m sure they never maintained it. Less than 200 hours. Used it last summer. This spring I changed the belt, blades, oil and all filters. Runs great. However, noticing leaks and then today while mowing the right side drive started...

Somewhere in the past I got it in my head that Moly Lithium grease was the best for all my tractors. I've been using it for years, and guess it's doing a good job. My zero turn has three pully's that my blades are attached to. There are two belts that turn the pully's. Just about every...

Can anyone tell me how to bypass the safety devices so you can get off without it dying? It's not just unplugging the seat switch. I did that and you couldn't manipulate the parking brake or pull in the steering arms without it dying. I just want to be able to jump off real quick, move a branch...

For whatever reason, my Hazzard lights and turn signals stopped working. I can here the relay clicking when I use the turn signal, but nothing when the Hazzard lights are activated.

Sorry so long Very scary, 1st thing is we realized from here on out we will not let people use equipment that can cause bodily injury on our property, we were lucky. GOD is the one who saved the day. Basic day working on the property, wife had to work this weekend and the neighbor (72 I...

Had a coolant hose come loose which set ofF the CEL. Reattached hose, filled coolant and now still have the CEL. Anyone know how to turn it off without the dealer?

I've seen the attachments to mount the sprayer to the mower, but what i'm looking for is a way to connect one nozzle to the mower that i can turn on and spray roundup while I'm mowing around buildings and such. Is there a company out there that makes something like this or do you have to create...

I am the very well satisfied owner of a Kubota ZD21 but it has been suffering with a starter issue for several years and I would like to fix it. The starter motor seems to run fine but the gear very often doesn’t engage to turn over the engine, do you think just replacing the solenoid or...

https://www.wmur.com/article/winchester-accident-lawn-mower-fatality/60769686

I just purchased a Z930R for my property. I don't have much in the ways of heavy grass/hills so this should be sufficient. Any gotchas on driving/handling/management that you can share or point me to? Thanks!

I have about 15 acres of pasture. Gentle rolling hills, not steep except near the pond. Ranges from moderately smooth to bumpy. I'm considering a new mower-- admittedly perhaps a stupid overkill-- 48hp diesel zero turn mower. Ferris IS6200Z...

I think I'm going to upgrade from my riding mower that doesn't cut well. This would be to mow about 1.5ac, including around a lot of trees. I'm probably going to look at 48-54" deck width. I don't need commercial level, but would like something that is still dependable and serviceable. There...

Hey folks... hopefully this is the correct forum as it relates to the hydrostatic drives on my zero turn. The main belt and/or tensioner went out on our zero turn the other day when my son was mowing. As you might expect that happened in a place that's not conducive to making easy repairs. I'd...

Hey guys, This year I noticed that my mower was moving around a little on my trailer and when I apply the brake on an incline it also moves. I started looking around and noticed that one of the cables is rather loose. As you can see I attempted to tighten it but it does not seem like it is...

I have a 283 massey. Was shredding all going great. Stopped put tractor in neutral. Left pto running. Got on tractor to go again and it wont move. Good pressure on foot. Feels as if it went into gear. Any ideas

I have a Kubota D1105 engine in a ZD1211 mower. When I tried to start it for the first time this year, the starter made a clicking sound. I knew the battery was going bad as it was getting slow to start last year, so I replaced the battery. However, when I turned the key over, the engine still...

Hi, I think I have two problems. Problem 1: I know that I need to replace the PTO clutch on my Bobcat FastCat Pro (61") ZTR. Do I need to buy the Borg Warner clutch or are the Chinese "equivalents" (on eBay for about 1/2 the price) good enough. Problem 2: When I took a look at the belt to...

Starting a new thread for my new mower, a 2021 Kubota ZD1211 60" side discharge mower. It had 95 hours when I bought it. I'll share my experience here amd contrast to other machines I have or have used. My only modification I have planned so far is to add seat isolators. The ones I bought...

local ad seller says it is a 2021 Kabota (sic) diesel 4x4 ride on mower photo says RANSOMES ... or something like that I have NO IDEA of Brand, Model, HP, year etc ... the ad, description, year, price, colour, and seller's reputation are all SKETCHY curious if anybody knows anything about it...

Neither the headlights nor turn signals on my G3038H are working. Fuse is good, and I can hear the flasher relay working when turning in either direction. The combo headlight/hazard/directional switch seems to be fine (at least it connects pairs of contacts depending on the position). I cannot...