toro

Just purchased my first Zero Turn mower so didn't know what to expect when steering it. After some 'practice' in our hayfield, I noticed that it pulled slightly to one side in Foward. After reading the Owner's Manual I adjusted the tracking via the adjustment bolts near the seat. That got it...

Hello to all, A friend gave me a 2021 Toro 21" "self-propelled" lawn mower. Filled her w gas and she started immediately. The self propelled feature worked fine at first, meaning pull the handle back and it would go. Gradually, the self-propelled feature became less operable. I would pull...

As the title says, I'm looking for an alternative for the rear drive tires on my Toro 4235 which have terrible traction. The OE are 18 x 7.5 x 8 lawn tractor tires with minimal traction. I'm looking to put a set of 18 x 9.5 x 8 atv tires on with a bit more grip but the width concerns me. Right...

I start the machine run it for about 10 mins the motor sounds like it's bogging down then it tries to overheat. Any suggestions? I'm new to this forum and do appreciate any ideas. Thanks Lucas

G’day Tractor Forum, I've recently picked up a Toro Z287L with a seized FH680V engine and a bad deck. I've cleaned up the engine, honed the cylinders, and soaked the heads in ATF. I reckon it'll run fine with new gaskets and oil. The deck is a non-original 52-inch replacement, but it’s beyond...

I'm beginning to hate renting anything from Home Depot. I bring home truckloads of dead/standing oak throughout the year. When I get enough, I rent a splitter from HD and split it all at once. Last year when I rented a splitter from them, I got it all the way home, before I noticed the ram...

I have a Toro Groundmaster 580d with a temp switch issue. The switch is part number 93-3526. When the switch is connected the machine will only run for about 2 seconds. When disconnected the machine will run normal. Does anyone know exactly what this switch does? Does it measure temp or...

Hello to all the zero-turn professionals. I am going to upgrade from my Gravely Pro-Turn 152. It is a great mower but I want something a little bit bigger. I was almost dead set on a Gravely 560 but the dealer I went to has Toro as well. I have never sat on or drove one until yesterday. I...

I have a Toro Wheelhorse that sat for a year and I’m trying to bring it back to life. Drained the old gas, got a new fuel filter, out on a new carb …and it starts right up and drives around in flat surfaces. But the minute I go up a hill or engage the mower deck, it sputters …assuredly because...

looking for piston rings .75 73mm model Mitsubishi k3d 105686 toro 72-4230

Hi Guys, New here and after a hand on mower choices. I live in New South Wales, Australia, on a 10-acre block. We mow a 2-acre well-watered lawn that extends onto a steep river bank as well as around 6 acre of paddock. The 6 acre paddock is open and flat apart from some drains at the front. I...

help looking for Mitsubishi k3d piston rings .75 for toro part number 72-4230 45fmj Tom

Hi, so my husband traded a tractor for a 1997 325D. rebuilt the engine, replaced some hoses, spent hour and hours on it and was elated to actually get it up an running. He mowed with it twice so far (does great) but today noticed the steering cylinder has sprung quite a leak. In looking for a...

Yesterday at a flea market I picked up the above blower for cheap. I am getting a little frustrated with it.. it will run on ether (just enough to test). But it is not getting gas. Pickup Filter is relatively clear, fuel line is in good shape. I want to get a rebuild kit for the carburetor...

I have a 2012 Toro commercial 48" walk-behind mower model 30078 with a Kawasaki engine. I'm trying to sell it and have been unable find any ballpark price ranges for it. It's as if the Internet has been scrubbed of such information. Any clues to sources I might use to determine market value...

I am looking to replace my current 50" Toro Timecutter zero turn with something a little bit more beefier. The Toro is fine but it not able to take the hammering of my yard(3 acres). I've heard good things about pretty much all commercial mowers and my neighbors have a Bobcat and a Scag and both...

Hey guys. Just wanted to share my channel with you. I work as a Turf Mechanic for many years and I'm still learning everyday but I may have some videos to help some people with certain issues on a variety of machines. I also work on Kubota / Case and New Hollands as well. Please subscribe to the...