seat

What is the best product for cleaning up the seat on a Kubota zero-turn? The seat is some kind of tough plastic. Will Armor All do it?

If you ever price a new seat cushion for your Kioti tractor you will cringe. New Kioti cushions are over $600. I replaced my bottom cushion 2 years ago. It already has cracked in several places. This time around I said screw it and bought a folding seat with armrests from Vevor for $120 shipped...

Case 580k seat cushions basically gone. Replacements are $$$$. Anyone use bucket seat to replace backhoe seat? What about wiring up heat and seat position buttons (on the seat itself) Has enclosed cab but will it mold? What about side airbags- disable or remove? I have the seat available. Dumb...

Saw all the videos. Wanted to put the motorcycle springs under my seat. They look and feel amazing. Only problem - they are a smidgen too long and the seat does not lock. Normally not a big problem, until my East Tennessee rear end bounces once or twice and the pto shuts off. Suggestions?

Will the adjustable seat tracks on a tc18 work on a tz18da

Hello all, The tension adjsuter blew off last night due to the heat and bad parts I guess (held together with plastic) - There are no replacement parts from branson/ Tym without buying the whole 1200$ chair and tensioner. Any ideas on a generic replacement that fits? it is probably in...

I am looking at a TYM T574. The lower seat cushion has to be replaced. I have not found it online. The entire seat costs $1270, and people say TYM's seats are not great. Is there a good aftermarket seat cusion that will fit? I don't think TYM offers the cushion by itself.

I have an AGT-HFRC72 High Flow rotary cutter I got for our 333G that was locked up. Only two parts make it work: the Hydraulic Motor, which I tested and works. I think the prior owner did not know there was a grease fitting that needed to be greased regularly, since there was none in it when I...

Looking to add a buddy seat in my 2010 5093e. Have searched the forum and seen where people have made them work with a 2013 model but unsure if there is any differences. Dealer doesnt show any official buddy seat that fits but wondering if anyone has made one work without too much trouble. Thanks

I have been trying to find a replacement suspension seat for my 2006 Kioti DK35SE with no luck. I have spent so much money already trying to buy replacement cushions but I really need the suspension seat. My back is killing me after only a few minutes on my machine.

I only have hilly terrain. the property is a series of stone push up benches and the short flats between. Due to this, I tend to move around on the seat quite a bit to stay centered on the controls. Today while moving soil to fill some low areas, and on several occasions in the recent past...

There is a company, Sailrite, which manufactures and sells quality marine upholstery products. They have a series of instructional videos on YouTube. The most recent is on repairing your fishing boat seat, which would probably work for redoing a tractor seat.

So if you don't have an 1850, you would not have the thrill of the self leveling seat. It's pretty simple, a couple of mercury switches on the back of the seat actuate a controller and a piston and it honestly keeps the seat pretty level and does so pretty quickly. But for years, mine has been...

I’ll need to replace mine, I didn’t realize that the foam was covering up so much rust down in the seat pan and so now it’s almost beyond a feasible repair. It’s been a great tractor and I’d like to find an original used seat in decent condition at a fair price if possible. Maybe someone here...

Hello guys. Got a friend with a John Deere 320 skid steer. We've been trying to figure out how to work around having to put on the seat belt. Same for the seat requiring weight in it. So far I figured out I can run the seat belt behind the seat and latch it. However if I get out and back...

Is there a suspension seat upgrade available for newer Kubota zero turn mowers? I'm helping my 80yr old father shop for a mower.

Has anyone build or seen a 3 point seats and racks for picking garden veggies? I plant tomatoes and peppers with a Holland transplanter. I plan on building a height adjustable seat and table for my produce totes. I'm trying to avoid bending over so much while picking. I will update this thread...

Ok, so quite awhile ago, i removed the seat on my mahindra tractor. It was all cracked, and when sat on, u ended up with a soaked rear. That was 3-4 years ago, i rigged a lawnmower seat, and off i went. Recently decided to put a sest on the original frame , because it adjusts up and down, and...

I have a JD 2305 that has always been an issue for my wife to operate. She is 5'4" and the tractor does not have enough fore/aft range in the seat adjustment for her. I am, finally, looking into fixing this. I have done some searching, and see that some people replaced the seat with something...

good morning all. this is in reference to a 13hp kohler mounted to an IR air compressor. short version is it appeared to be flooding the engine with fuel, so I removed the carb & bowl and after removing the plastic float, noted there did not appear to be a rubber needle seat present. the oem...

I have a 20 pound mini Aussie that pretty much goes everywhere with me when I can make it safe. I have a Kubota M6 with an instructors seat and looking for something that can go on that and she will not fall out of. I run a snowblowing route and between going ahead and back she falls off of the...

Flew back from California the night before, got up early and did six driveways in the neighborhood. This Virginia storm was perfect snow and little to no sleet/ice where I am at. I strapped four suitcase weights to my rear blade and attached PVC to the loader edge. The tractor impressed as it...

I am finding the spring adjustment for my seats is frozen up. Frozen up as like welded up. Cannot get it to loosen up. This thing has some BIG heavy springs for the seat. I guess it has been like this from new. Finally realized the adjustment info in the manual is a joke. Nothing happens no...

Installed a TigerTough seat cover for the tractor today. These are custom fit for your seat. They aren't cheap but are very high quality, American made and have a great unconditional warranty (at least the website says so). One issue I had was installing the back seat portion. It was too tight...

For those who have a front spring-suspension seat on their Kubota, here is an easy update. My 240LB would bottom out the front seat suspension springs against the rubber bumpers inside the springs when just sitting in it. I looked at options to replace the seat but it's a swivel seat for BH use...

I would like to install a bypass seat safety/cutoff switch for my 2023 Kubota L4060 ROPS tractor. I do not want to permanently disable it, just be able to switch it off under certain limited circumstances, but keeping it engaged most all the time. I have attached a photo showing the wiring and...

Getting ready to remove my fuel tank because junk in the tank plugged the outlet line causing the tractor to stop running. Looking behind the seat there is a feature shown in the attached picture, the picture looks like a cigarette lighter but I doubt it, any idea what this is for? Thanks!

Anyone ever found an all metal seat that works?

Has any one upgraded there tractor seat for a CK 27 brought in 2013 and what brand did you use looking for something with arm rests

Is the air seat worth the extra cost on M7060 cab model? I know the price difference (few hundred) and I understand the actual seat is the same and just the suspension is switched out. Mainly haying use (4-8 MPH travel speed) and road work.

I recently bought a used L5740 ROPs tractor and the seat was shot. I ordered another one. During this project I noticed the suspension assembly had problems. A bracket was busted that I couldn't repair. Also, the gas strut (Tokico B030017300) was shot. These are over $150 from Kubota. This is...

Summit Tractor seat engine shut off issue. I have a second issue which recently appeared. I place the tractor in neutral, setting the emergency brake but when I get off the seat the tractor shuts off as through the brake is not set. I noticed when I set the brake sometimes the dashboard light is...

My seat is pretty bad shape(cushion part,bottom and back).Looking for parts but looks like you have to replace the whole system?Calling dealer tomorrow to get there input,found some stuff on line but any confirm fit?thanks for any help

Ok , I was just putting the seat up because I wasn’t putting the tractor away tonight as the rain started and somehow the wire got caught and the switch got yanked out of the seat. Nothing really appears terribly damaged but I can’t figure out how that switch was actually afixed inside the seat...

Machine: Deere 757 ZTrak Engine: Kawasaki 25 hp V-twin Okay, most of us have (or have had) these ubiquitous Kawi V-twins on our mowers, we all know this engine. We all know it's good to check and/or adjust the valve clearance every few years, Deere happens to recommend 300 hours... all good...

I need to bypass the safety switch, are there any halfway elegant solutions to do this?

As title says, i need to replace the seat and suspension. Its ‘bout worn out, plus I’m older and fatter and I’d like a softer, non-bottoming ride. So a new seat with good suspension and travel, if anyone can recommend one that fits the Deere 4x20 line of CUTs. Thanks, gbw

I am replacing the seat on my Ford 1920 tractor and need to remove the hinge pin that lets the seat flip forward. I can not get it out. I cut the pin in two places (far left and right) to get the seat mounting plate out of the way - the part of the pin in the center that is still attached to the...

Time to get rid of the factory plastic so far haven’t found a cover made for the Grammer S85/90 air seat. Anyone had any luck finding a cover that fits?

Looking for feedback on seat replacement for 2004 JD 5205. Have read some have went with units from Tractor Supply. Some satisfied. Some report not enough cushion in seat. This seat has some spring left, but nothing like the seat on my 5303. Have read some comments about replacing just the...

Looking for something in the 40 to 50 horsepower range, four wheel drive with a cab and preferably a shuttle shift not a hydro and under 10,000 lb with fluid in the rears. Had a tractor for many years and traded it for a skid steer 6 years ago but due to health issues I have a hard time getting...

Purchased 11 months back, as stated the air seat leaks down in about two minutes & ride then becomes unbearable. Apparently during assembly hose barb fitting was over tightened cracking the plastic housing of the control switch. Dealer has supposedly been trying to find a new switch but claims...

Can someone tell me the correct part number for replacement seat on my tractor the one I order is too narrow my fat behind can't fit in it

Just bought an older 9540 So far very impressed with its build quality Has anyone swapped the factory seat with an air ride seat at all ?

My wife has bought another of those recliners that push her into a standing position and given the old one to me. After little more than a year, it's become uncomfortable to sit in. My theory is that the seat pillow has gotten packed into it's case as the lift mechanism has pushed her forward...

I bought a new MX5400 in '22, and I am almost ready to completely disable the seat safety switch. It entirely too sensitive, and and just about any change in position on the seat will shut the tractor down. I'm 170lbs, and its aggravating trying to run/watch any implement behind you without...

Is there a shipping bolt or something securing my seat in place when it comes from the manufacturer? I’ve pulled the lever and twisted the knobs but my seat just doesn’t slide forward and back or go up and down.

I want to raise seat about 3 inches . I am thinking of removing seat bolts and use 3 in or so box tubing with longer bolts. I'm too tall for seat. Looking for ideas? Pictures Or suggestions Thank you

Has anyone found a mesh seat that can be used on mower’s and tractors?

Hi all...I have a bad lower back and want to upgrade my OEM seat to one that has more suspension and back adjustments. It doesn't have to be top of line...just a good seat with better shock absorption and perhaps a few adjustable settings. Not wanting to spend over $500 if possible. Thanks..

Looking to replace the seat on our satoh beaver. Any recommendations on something that would be compatible with the current seat mounts?

OOOOPSIE! My first time removing the backhoe and I put too much pressure on the seat post when lowering the boom. Is this as easy a fix as i'm hoping it is???

Bliss! If anyone else is sick of their crappy OEM Kubota seats with no suspension I've found a relatively painless upgrade that will work for your M59/M62 I took the plunge and ordered the Kubota "L6026" air suspension seat made for the L6060 cab tractor and found that it fits with very little...

I have been looking for a seat for my "ultimate garden tool", known to the public as a BX22D TLB. One of the dealers I use advertised a seat for about $150 then after I ordered it they notified me it wasn't available, but they had the $400 one in stock and would be happy to send it. Right, a...