rough

  1. I

    Smoothing rough hayfield

    Has anyone had much luck smoothing out a rough field? I have a 12 acre field that had been plowed when I got it and then they guy tried to disc it when it was muddy. Left it a bone-jarring mess to drive on. I've had someone come in and disc it again and then drag it. It helped some (the largest...
  2. H

    Stalling/Very rough

    I have a TYN T264 that after around 20 mins when tractor gets warmed up begins to get very rough idling and eventual stalls out. Tractor has about 200 hours, new fuel and air filter installed but didn't help, any help would be appreciated.
  3. amarsh64

    Moving rough lumber

    I found out today that I can pick up and move 60 pcs of rough 2"x4" x 11' 6" up a small hill closer to my garage build . That is the average length give or take in the pile. Wasn't really sure how much the lift weighed at that point or if it would take it but no real problem. The loader was a...
  4. Q

    Rough times for whitetails?

    Other than the recent remnants of Hurricane Helene, it's the toasty dry here all summer. (No damage, no power loss for us) Our property is on a ridge. Ours and our neighbors land are laid out like a hand with gullys and ridges. The gulllys are heavily wooded and surround about 3/4 of our...
  5. WinterDeere

    Kawi 25hp V-twin running rough

    The Kawi 25hp V-twin on my ZTR started running rough today, while tooling around the yard harvesting walnuts. This is a low-load chore, but can take a few hours. I had noticed last week when doing the same activity, that the RPM's seemed to be climbing a bit more than normal on the downhills...
  6. E

    Runs rough when hot

    Hi, everyone, I've had a Ford 8n, has run well for years, I've accumulated about 150 hours on the present coil, points, plugs, condenser. I cleaned the points, set the ignition timing and tested, it was running great. After an hour of mowing, it lost power and was backfiring through the...
  7. D

    Rough running 9n

    I was wondering if anyone has ever had a rough running / backfiring issue when they had a loose pole on the starter ? It’s a 12 volt system and everything else seems to be ok but the stud on the starter is loose and will not tighten up properly. Any help would be appreciated thanks!
  8. J

    Ford 9N Rough Idle

    1941 Ford 9N will barely idle and will not throttle up w/o backfiring. Will sometimes run OK for a few seconds, then goes back to rough idle. Cannot throttle up at all. Ignition System: 1. Looks like a brand new distributor+coil was installed from previous owner. Tore apart, lubricated...
Top