new holland tc45

New Holland TC45 diverter block leaking at supply junction. As a novice, should I attempt to repair leak in pto diverter block? Does it require removing the block from the tractor?

It been awhile since posting. I have a new problem with my TC45d. My PTO does not seem to have any muscle. It turns on and spins but if it gets loaded it just stops. When tilling I have to lift the 3 point then it will start to turn again. I replaced my PTO clutch 300 hours ago because the...

Hi I have a new holland tc 45 and the manual calls for Ambra Multi G 134 hydraulic /trans oil. Does anyone know the tractor supply oil that is equivalent. I have looked at all of the hydraulic oil they carry in stock and none have that mentioned in there specs. The manual also says to use that...

My TC45 has had some issues holding a steady engine speed for some time now but it was just a nuisance because I could adjust the control to get the engine speed I need. Recently it did a thing where I brought engine speed down under no load and as it came down to idle it made a loud...

I have a New Holland TC45 that has been slowly losing it's hydraulics to the FEL and 3-point hitch. The external hydraulic pump has also been making an intermittent whining noise so I had it rebuilt with a new seal kit. That helped some, but it seems like it's starving for fluid. It starts...

see a woods bh 9000 for sale and wonder Is it too much for my tractor? Should I stay away from a 3pt backhoe?

I just got this tc45 running but I bought it from an older lady and she said it has not been run in at least 5 years. Once it started it had a very loud bottom end knock. I have not removed the pan or filter yet but if anyone has any ideas I am all ears.

I posted this in the New Holland Owning/Operating section, but I thought I may have a better chance of getting this answered here. I have a New Holland TC45 with a stuck fuel rack in the injection pump. If I could remove the injection pump I would just have it rebuilt but the problem is I...

First Post, so I will start off by saying hello and thank you since I have used this site many times in the past to help with issues on my other tractors. Here is my issue, I just purchased a TC45S that has been sitting for a few years and I am attempting to get this thing started but have been...

I recently purchased a 2001 TC45 with 950 hours. It was in need of some Basic repair. The tilt steering would not work but fixed with a new gas shock. The other two issues were the hydro wants to creep in the forward position and the platform was in need of replacement. The tractor ran fine and...

This is my first post so be kind please! I currently have and old Pequea 18 ft trailer for hauling my NH45 w/backhoe & loader. I also have older smaller two axle cam dump. I am thinking of buying a new dump that can handle tractor and selling off the two other pieces. I am currently looking at a...

Hello all I am new and this is my first post so please put up with one more newbie. I have a 99/2000 New Holland Tc45 with weak hydraulics at FEL and rear 3pt that now requires to rev engine to lift either. I was moving a Bagster full of shingles and FEL struggled to move it so I dragged it to...

I just picked up a TC45DA and have a couple of questions What are the two switches to the right of the operators station for? What does the designation "DA" represent? Thanks

Hi all new to forum say I have a tc45 that has a leak at the base of the steering column power steering motor seals I think can't find any where on the web to find seals any help?

I have been discussing this tractor with no power to the dash. I have replaced the battery and cleaned all connections including the ground on the frame. I have power going in and out the 40 amp fuse above the starter. How do I remove the upper and lower panels to continue checking the problem...

Looking for a front-end loader for my New Holland TC45 tractor.

Loaded the tractor no prob went to unload backhoe inop front loader ok changed positions on diverter valve no change no pressure going to rear hydro lines feel no pressure going threw valve when changing positions what next is the diverter valve no good

I have a 2003 New Holland TC45 gear drive with very low hours (<200). Everything was fine when I parked it last week. Now the clutch won't disengage. I can crank it, but I cannot get it into gear. The forward / reverse and gear selector levers don't grind but wont go into gear. The range...

Over the summer, I knocked off one of my hazzard lights completely off and the other about half. It didn't bust the case, just pulled the nutserts out of the plastic housing. I thought I drill completely through the housing and use some nice stainless bolts to replace the old one. Well, in...

Im looking at a NH TC45 with loader, 450 hours, hydro trans, 4x4, 2002 year model, for 15 thousand is this a good price for a 3 year old unit!

New to the group, have enjoyed reading others post. I have been looking at NH TC45s and JD 4120s but an opportunity has come up for me to get a DK55 with 10hrs on it from the dealer (with the poorly reviewed KL1595 loader due to its self leveling capability limiting roll back) for $23K. This...

will it work

What you guys think would be the best price to shoot for on a TC 45 Hydro, w/ loader in Florida? I would consider traveling to Georgia, Alabama, or North Carolina, Tenesee Have a John Deere 4300 but need bigger machine,,,thanks,,gott

I just stumbled across the Case IH site and was looking at what they had to offer as far as compact tractors and could not help but notice that there D45/DX45 were the identical tractors (except paint) to the TC45/TC45D spec for spec.... Has anyone out there noticed this? If this is true I...

Per MarkV's request, here are some pictures of the grapple forks mounted on my TC45. The retrofit grapple was ordered from Attachments International http://www.attachmentsintl.com/skidsteer/skidsteer.htm My NH dealer ordered and mounted the grapple. I think the total cost of the grapple was...