john deere 670

Hello I purchased a JD 670 with a mid mower. I’m trying to remove the mower deck got to disconnecting PTO and can not figure out how to. Can someone please advise or show pictures of the procedure thanks

Hey All, I am looking at switching my 2WD 670 from the previous owners lawn mower setup to something more like a row-cropper. It has some rather worn out and very wide (31x15.5-15) turf tires on it now. I would like to switch to bar tires for pulling a plow/disk/cultivator, but a couple of...

Hello good TBN people. Firstly, I apologize if there's already a thread on this. I seem to be having a difficult time using the search function in a meaningful way, but I did poke around a bit before posting. I've got a Deere 670 4WD with P/S and front end loader. After about 15 years of...

I've been looking for a not-too-expensive used tractor to maintain my 800' gravel driveway. The driveway is pretty much level all the way with a couple of spots with gentle grades. I've found a low-hours JD 670 4WD that I'm going to look at tomorrow. A lot of the comments in forums I'm...

Does anyone have experiences removing the rockshaft cover on a 670? My 3 point only moves a small amount and I am thinking the lever control linkages may be bent. While digging a post hole is only came up 1/2 way. The loader works fine so I am suspecting my pressure is good. Anyone seen those...

So I purchased a JD 670 on Sunday morning, its a pretty clean 1400 hour machine with a few dings on it but hardly any rust and seems to run well. It has a bush hog 1846QT loader and turf tires... but neither of those things are very important to the question at hand. What is related is that the...

HI all. A little over a ago we purchased a small farm that came with a JD 670. It also came with a mid mount mowing deck and a rear mount snowblower. Both have been great! What we really need though is a front end loader. Unfortunately Ours does not have the forward hydraulic hook up. We had...

Hello, I picked up a 1996 John Deere 670 (850 hours, loader and mid-mount mower). What's the procedure for removing the mid-mount mower for service? I picked up a service and operators manual but there wasn't any information in either. Thanks!

I've got an early 90s 670 that has been sitting in a barn for a couple years. Everything was working fine when it was parked. It runs good now, but after sitting the 3ph has zero movement. The arms move freely by hand, and the pump is moving fluid. Screen is clean as well. Is there a likely...

Hey everyone, first post on this site. I have a JD 670 that the temperature gauge quit working on, I switched the fuel gauge with the temp gauge and it worked (needle just goes backwards) so I know that its the gauge and not the sensor or any wire in between. Is there any possible way of just...

Is the JD 670 totally mechanical? The mid PTO has been a little rough, grinding when being engaged. Now it won't engage at all, it just grinds. Any thoughts?

hello all, i recently purchased a 1996 JD670 FEL tractor. i am looking to get a idea of some attachements. i would like to get a set of pallet forks for it. Also looking for a backhoe attachment, what other backhoes will fit my 670 besides a john deere model 7 backhoe? Also please post some pics...

Hello all i recently purchased a 1996 JD 670 tractor with loader that was sitting for approx 1 1/2 years. i went threw it and got her running. I did not have any fuel at first when i cracked injector lines to bleed system ( yes i know it is a self bleeding system but i always bleed small diesels...

No power. Battery is good. We just replaced battery terminal clamps. but no power! Where is the fusible link?

I have a 1987 John Deere 670 with a 60 front loader. I just inherited this tractor and I'm hooking up the 60 loader, which has been done except for the hydraulic hose connections. On the tractor side there are 4 ports which are color coded and numbered. Unfortunatly the hoses on the loader side...

Hi, Im brand new here. Ive read several post on this site before and seems like a great place to get some information. I have agreed to buy a John Deere 670 sub compact tractor from a friend for 1000 dollars. The compression is so low that it will not start. Engine turns over fine. Ive been...

need to replace hydraulic hoses and repair leaking hydraulic cylinders

I'm looking for the best source for brakes or a brake kit for a John Deere 670 compact tractor. I see parts advertised on ebay but I'm not sure if they are good quality? Any recommendations would be appreciated. Thanks BEL169

I have a John Deere 670 Compact Utility Tractor that needs the headlight switch replaced (corroded and frozen up). First step to getting behind the instrument panel is to remove the steering wheel, but I just can't figure out how to do it. I removed the little plastic cap and the big nut and...

As mentioned in title, I have a JD 670 with Model 60 loader with one of the bucket tilt hydraulic cylinders leaking like a sieve. Does anyone have info or literature on how to rebuild the cylinder? Or should I pay someone to do it? Should I buy a new cylinder? Or is there an aftermarket that...

I hate to be a mooch for information but I just bought a John Deere 670 with 60 loader on it and three of the loader pins will not accept grease at the fitting (I believe it sat for some time). I have to pound out the pins to clear everything out but they are really bound up in there something...

I am looking at a used JD 670, it has MFWD, mid and rear PTOs, but, no front hydraulics and wanted to know how hard, or, how expensive would that be, to add on, and, if even still available ?

Hello, I have narrowed my tractor choice to either a 670 or 770. Both have very low hours, approximately 500 and have the same general features and condition. The 670 is $5,000 and the 770 is $6,500. For $850 more, I can get a 261 finishing mower attachment for the 770. My initial game plan is...

When the key is on I can hear the click from the seat safety switch and PTO switch, but not from the neutral safety switch. Does anyone know how to bypass/defeat it to test? Thanks.

I have an 1991 670 my fater-in-law gave me. It has been sitting and hasn't been started for years because of his health issues. Overall it's in pretty good shape considering, and it only 330 hours on it. The battery box is rusted out and needs replaced. the front grill is missing and needs a...

i have a john deere 670 tractor i was wondering if any one had any pics of a cab on it or if anyone make one for it not really looking for a canvas cab would like to have glass any info would help thank you

Getting my New to me John deere 670 compact (FEL - PS - 4x4) ready for winter and ran into 3, what might be classified as stupid questions - but here goes. 1. After draining oil I filled at top of valve cover. BUT there is also an oil fill on the right side of engine by lower radiator hose and...

I 'm looking for a OEM Dual Selective Control Valve for a John Deere 670 compact tractor. I want to mount a loader on this tractor.

Hi, I'm a new member. I co-own a John Deere 670. The seat is getting to be in really bad shape. I'm wondering how people have replaced theirs. There seem to be some available for it, but quite expensive. And some cheaper "universal" ones, but I can't quite figure out how to determine if...

I have JD 670 with factory 60 loader. Under the left foot there are 4 quick couplers that obviously control UP/Down and tilt. One of those quick Couplers is leaking like a sieve. I'm thinking I need to relieve the pressure on the lines before I remove and replace that coupler. Where / how do I...

I am new to this site i figured it would be a place to get some help. While snowblowing with my tractor i uncovered a blanket which was sucked into the snowblower. when i saw the blanket i immedietly pushed in the clutch so i wouldnt damage anything. after getting the blanket out of the...

im doing a clutch on a john deere 670 and am in need of the parts diagram and it is a duel stage clutch and is also the same as a 770 if anyone could help it would be much appreciated

Last winter, while pushing snow with my 670, The belt started to squeal and I smelt rubber and the battery light lite up. Since then I've run it 3 times. Battery light is still lite but starts easily (battery seems to have and hold full charge)but after about 10 - 15 minutes use it starts...

I have just bought a small PowerHorse log splitter to use with my 670. However, I can not find any way to identify which two of the four hydraulic connectors to connect the hoses to. There are four connectors just forward of the driver's left foot, numbered 1,2,3,4 in a clockwise direction...

found 1997 jd 670 2wd with 650 hours and worn out 60 inch land pride finish mower that needs couple hundred dollars work which exceeds its worth in my mind, this is bank repo looks very clean top to bottom they are asking $5500, not a JD person was wondering if fair price still gonna try and...

Just bought a JD 670 with 60" belly mower. Got it mounted and surprised how well it works, Keep throwing belt. Belt is quite worn. I noticed spindles getting real hot and I think it would be a good idea to rebuild the deck before putting on a new belt. On the JD site they have listed 3 decks for...

I have a 95 670 with a MMM. Is there anyway to lock the mowing deck up so that I can use the grader blade without dragging the deck? thanks..

Accidently made this post in pricing..Im new...anyway just bought this tractor off of my neighbor for $5500. Its a 1995 4wd with MMM and rear blade and 412 hrs. I bought the imatch too. I am new to this site and have happily put it in my favorites. I have been reading on here for 3 hours...

off of my neighbor for $5500. Its a 4wd with MMM and rear blade and 412 hrs. I bought the imatch too. I am new to this site and have happily put it in my favorites. I have been reading on here for 3 hours. The mmm deck belt seems to be getting very hot as does the pullies is this normal...

It is getting extremely more and more difficult for me to get parts for my 1985 JD 750. These days I am hearing more of "no longer available". I know this is a Yanmar product as is the above mentioned tractors and was wondering if those tractors are also tough to get parts for especially since...

I just purchased a John Deere 670! I am curious if anyone knows exactly how much this tractor weighs? Yes it has a FEL, but it's not a JD product and I assume it's about 400-500 lbs or so. I'm shopping for a small trailer to tow this thing short distances., so I'm considering a short...

I have been looking around for a used small older 4X4 tractor, around 17hp. I just got a call from a friend who gave me a lead on a Deere 670. I have been looking around the net for info on this tractor and am confused on exactly what it is. Some say it is 16hp others 18hp and some even 20hp. I...

Is it true that an FEL for this model would be exceptionally difficult to handle and steer without front wheel drive and power steering, which our tractor doesn't have? We were told by the dealer not to put a FEL on unless we had these features. Has anyone had experience with this model...

Thanks for your patience guys as I get the hang of this site. In my first posting (that was deleted due to a bad link to a JD site), I described a problem with a used JD 670 tiller that I just bought. When buying, I was told that it needed a new slip clutch. I like to fix things myself so I...

Not sure where this went, but the site with the manuals was copyright protected, so likely deleted by admins. Good that they are on top of this. The clutch appears to be the bellville spring arrangement. The bolts (6) with lock nuts are to be set at gap of 4mm, and the bellville spring...

Greetings- I am new to this forum, but am already impressed by the wealth of knowledge that is contained here. I am a vegetable farmer in New Hampshire with a growing (no pun intended) business. We have always leased equipment in the past from a farm neighbor, but they have moved away. As we...

Newbie here with some Q\'s on the JD 670 I'm looking at a 92 JD 670 with bellie mower attachment only...Meter reads 804 on the clock. What would be fair market value for this unit? I've already checked Machinerylink. Just asking what the public thinks the value is..lol The tractor is clean and...

There is a Deere 670 (18.5 hp) with 60 inch belly mower and 5 ft bush hog for about $6,250. Can this tractor run a 5ft bush hog? Is this a good price? How much more will I have to spend to add a loader? Would also appreciate any comments about this tractor (good and bad). I will be using...

I finally tracked down a 60" MMM for my 670 and it has all the attachment brackets, but I simply cannot figure out where the lift arms for the mower attach to the lift. I haven't ordered the manual for the mower yet, but I've figured out everything except the lift attachment. I was told that it...

I have received a JD model 670 4x4 compact tractor from my relative's estate but don't have any idea what it might be worth or what year it is. It only has 632 hrs and is very clean, has the big turf tires and runs great (don't believe it spent any time out of cover). I know the model number...

The JD 670 does have the 540 PTO speed. I bought the tractor.. for me it will be awesome. Has a quick disconnect FEL, too! Thanks!

I am thinking of getting a used JD670. Does anyone know what the rear PTO speed is on these tractors? I had gotten a Bolens Iseki only to find out the rear PTO was 472 and while it would work with new bush hogs, it would not cut or work as well in high grass. Is there a difference between the...

I recently bought a 1990 Deere 670 with 610 hours. The deal included the FEL (factory) and a rear finishing mower. I asking anyone who has (or had) this tractor to let me know what they thought of them. I'm a newbie to compacts...except for running a Ford Backhoe (big'un) in the late '60's. My...