john deere 6410

Hi, I have the jd 6410 engine rebuild and the engine loom has some issues as the tractor does not start. Before it was starting OK, now the dash bord is lit up and when I tried to start the engine will switched off, i did replace the loom cabin plug L102313 {no. 9 in the photo} as the previous...

I'm having trouble with the hydraulic system overheating on a John Deere 6410 that was built in Germany. The whole transmission gets very hot to the touch, at times it has gotten so hot the transmission does not shift between forward and reverse anymore. Quit a bit of diagnostic work has been...

Good evening, new to the site. JD 6410 hydraulics are overheating due to scv valve sticking, or so I think. I repaired the brake valve already at this point which fixed one problem. When I pull the scv remote handle I can hear them and when I let go of the handle it continues until I move...

forward and reverse not working

I have a John Deere 6410. seems to choose on its own when the day is done and just won't move after cutting hay, bush hog, etc. Sometimes you can restart it, or let it rest for a few minutes, and maybe you can limp to the house hoping it doesn't do it again in the middle of the road. I have...

I WAS BUSH HOGGING, LISTENING TO RADIO RUNNING WELL, GRASS WAS NOT TALL AT ALL, ALL OF A SUDDEN RADIO STOPPED, LOOKED DOWN ALL DASH GAUGES AND ALL HAD STOPPED, LOOKED BACK PTO HAD STOPPED, TRIED TO LIFT ARMS, NOTHING, BUT TRACTOR RUNNING GOOD, DONT SEE FUSE BLOWN, ANY IDEAS ? THANKS ALSO HEATER...

I WAS BUSH HOGGING, STOPPED TO GET SOME WATER TO DRINK, WHEN I GOT BACK IN IT WOULD NOT START WITH KEY, I REPLACED THE SWITCH, THEN THE SOLENOID, AND NOW HAVE CHANGED THE NEUTRAL START SWITCH, STILL WILL NOT START WITH KEY, LET ME ALSO SAY, IF I CROSS THE SOLENOID IT WILL CRANK AND RUN FINE, I...

Guys I understand the MFWD solenoid needs permanent power to keep it out of FWD. I have tested the solenoid,it generates magnetic field. I have removed the valve assembly, that also works fine with solenoid attached. But, the tractor remains in FWD. What can be the problem? Albert

yes i have a 1999 john deere 6410 with 640 loader it has a powrquad transmission. the tractor at first when operating it would drive and shift then start beeping when traveling. went out and started it one day to go mow and tractor would not go into forward or reverse. looked into it and...

I can see the diff lock switch is powered from ignition. Also, relay K110 terminal 30 is not powered from a fuse. Can you guys help me complete the drawing?

I have the European edition. Can you guys review my 2 drawings. I need help with diode V104 and fuses F110 and F111. How about a schematic? that will be fantastic!

Guys Can you help with basic wiring in picture. Albert

2000 6410 powrquad 24 speed. Round baled with it 2 weeks ago. Everything was fine. Last week I went to use it and it will not move. Low trans pressure ligh and stop light flash when engine is running. PTO does not come on. Test light comes on at solenoids on transmission. 8.5-11 ohms on...

I have a 2001 6410 tractor that won't start all of a sudden. It was fine the day before. My first guess was the starter went bad, but after checking to see if the solenoid was getting power while turning over the key I realized that it wasn't getting power. My next step I checked all the...

My 6410 is running hot according to the temp gauge. But when I check the temp with a temp gun, it shows its running around 190 Any ideas????

Hello to all I'm new here, hope I can help people and get some help for myself. I've got a 2000 JD 6410 it acts like its got a misfire but when I block the lines all 4 injectors are firing the same and there is no change in its sound, it's like it's got a 5th cylinder that's not firing that it...

Ok sorry only way i knew how to post this wher it would be seen! Stoped working all at once! all remotes work fine! thanks !!!