air

I'm upgrading my commercial truck from spring suspension to air ride. I am using a modified York 210 compressor to provide air to the system. This compressor doesn't have an unloader valve on the compressor like a commercial diesel engine style compressor. The air dryer I am installing is a self...

Just got done refitting 3 pin on FEL buckets fron pin on lugs to SSQA plates, something I've done a lot of in the past using a large angle grinder and thin kerf abrasive discs to remove the welds that secure the pin on lugs welded to the backside of the buckets, a tedious and dirty job even...

While removing the fuel injectors I broke off a couple of the hose nipples from the air bleed system. Having a very hard time repairing them with epoxy and jbweld. Can I put the injectors back in and not put the bleeders back on?

My 424 is 4 years old with 600 hours on it. I recently noticed the air filter housing assembly is just loose enough that it has worn a fairly large gash in the top of the radiator. I’m surprised that the plastic housing is the winner in a plastic rubbing on metal situation. I stuffed a bit of...

Need to plumb out my shop in the not too distant future. Was thinking about using Sch 80 PVC. I have heard of many people using it without issues. Anyone out in TVN land using this in their shop?

Has anyone ever tried changing the air filter assembly of a 2515 to the 3515 assembly?

I used to have air lines run in my shop because I painted and needed the moisture removed. At the compressor I had a flex line to a vertical line that crossed over and dropped down to my moisture filter for painting. It looked something like this It worked great but I just finished insulating...

A strange air-con problem has recently surfaced in my 5yo Kioti RX8030. Starting a couple months ago, every few weeks, it just won't pump out cold air one day, then either later in the day when the engine's restarted, or the next day, it'll be normal. When it first happened, I thought "Uh-oh...

On my Kubota L4610 HSTC, The ac compressor clutch cycles on 10 seconds, then off 10 seconds. About 65 degree day. 2000 RPM. Sight glass only has bubbles @ beginning & end of cycles.Would this be considered normal? I presume that a pressure switch might be causing the cycle? I think it may be...

..... used to be, I'd just pick up a pack of canned-air dusters @ Costco.... turns out, they dropped them a while ago..... Walmart is $13CAD/can - not paying that. I use it primarily on electronics, so need clean/dry. Not interested in yet another battery-powered cheap tool, and while I can...

Hi - somewhat of a novice here. I have a Mahindra 2310. I had a hydraulic leak on a rubber boot on the right brake rod, and I lost a lot of fluid. I replaced the boot and refilled the hydraulics (about 4 gallons), but the hydraulics aren’t working as they should. Before the repair, I had no...

Are the air line kits available at like Northern Tool and Amazon a good option? I want to run air around my garage it’s 20’x30’. https://www.northerntool.com/products/rapidair-maxline-3-4in-100ft-master-kit-compressed-air-piping-system-model-m7500-20923 https://a.co/d/bsraXO5 What concerns...

I've got a weird problem. Suddenly I have air in the water lines in my house, especially the hot water lines. I have a well and rather than a bladder tank, it has an air control valve tank which means it keeps a specified amount of air in the pressure storage tank at all times and bleeds off...

Modern technology is amazing and makes life so easy.

Does anyone know where to find parts, information, manuals, etc for an older F.E. Myers air blast sprayer? I’ve looked all over in a combination of searches and I can’t find anything solid. Just units for sale or formerly for sale. Looks to be a fiberglass tank, probably 70’s or 80’s model...

Not sure if this is the right place or not but here goes: How do you store your air compressor when not in use if you don't have an automatic drain valve? Until very recently I've always made due with the small portable contractor pancake compressors and when done utilizing them...

Wife wants to build a detached garage. It will need it's own seperate electrical service (I think). Current garage would be converted into another room. I have a 20 gallon Campbell Hausfield compressor (horizontal) on wheels. GENERALLY, this has been good enough however, I've used a grinder...

I have a Husky Pro 60 gallon, 230V, 3.2 HP air compressor. Since I moved it from the basement to the garage it will no longer compress air beyond 30psi. It stalls out almost like the pressure switch is not functioning. I have replaced the pressure switch, the run capacitor, and the pressure...

I've recently bought a small replacement air compressor. I've assembled it according to the instructions yet it is not running up to a 'useable' psi. The power source required is a standard (Australian) 220V 50Hz. My only thinking is that, perhaps, I need to leave it 'plugged in' (not running)...

On a T394 with cab, there are 4 intake vents towards the back of the tractor in the cab. 2 on the rear up top and 2 on the side up top. Should these be opened or closed to allow for air recirculation in the cabin without pulling in outside air. Thank you

Tow vehicle: 2015 Ram 1500 4x4 Hemi Outdoorsman with "HD" rear springs Heaviest trailer: 2016 Big Tex 7000 lb. landscape trailer with winch and dual deep-cycle batteries mounted on tongue assembly Problem: Tongue weight is a little higher than I would like for vehicle attitude, but offroad...

My Sawsquatch slipped off a higher cabinet and hit my air compressor. I can only assume the shipping container was jostled enough for it to slide off. This could have been from storms this spring. Could have been a possible earth tremor too. Anyway, No damage to saw but a piece of compressor...

I am building a new 44’ x 48’ workshop that will be next to my existing 40’ x 60, barn. Instead of buying a new compressor for the new workshop, I am thinking about running a 200 psi rated black polyethylene pipe from from the existing barn to the new barn. Any opinions?

Hello, I have been restoring my grandpas old cab 393 Massey Ferguson. The cab roof air conditioner cover is missing. It seem that the part is obsolete through Massey and I have had no luck finding one through tractor salvage yards yet. This is the Massey part number 3478448m91. Does anyone know...

I am looking for a complete air cleaner assembly for a Ford 841.

I have a 2008 MF-1533 with Synchroshuttle transmission. If the tractor sits for a day or so the 3-point hitch and FEL do not work at all…power steering works fine. To get up and going I have to open the bleed screw on the rearward hydraulic pump and turn the steering wheel until the air gets...

I've been curious about the difference between air CFM vs SCFM, ever since I bought a Harbor Freight compressor some 15 years ago, rated 5.1 CFM, that couldn't keep up with a HF die grinder rated to need 4.7 CFM. Oh well that's just HF's marketing. But recently looking at something from HF...

Well, not really boom, more like a very loud Pssssst! I have a 2655 cab/shuttle with 300 hrs on it. Fired it up to move a trailer around yesterday, and switched the AC on as it was warm for a change. Idled to the back of the lot to hook up, and the high pressure relief valve on the AC blew...

Has anyone had issues with air conditioning ? I have Rx7320, Replaced entire unit in roof and compressor and still barely working.

I have Tool Cat 5610 and I am unable to get air filter out to change. It has broken and full of dirt. How is the best way to get to the housing to remove the whole thing

When i want to clean the filter i saw the missing material from the filter.I thing some of the particles entered into the engine.How can cause this?

1958 Ford 661 Workmaster. Looking for the internals to the Air Cleaner. Filters? Gaskets? Screens? Does anyone know where I can find the parts -- whatever is internal to the air cleaner.

Bliss! If anyone else is sick of their crappy OEM Kubota seats with no suspension I've found a relatively painless upgrade that will work for your M59/M62 I took the plunge and ordered the Kubota "L6026" air suspension seat made for the L6060 cab tractor and found that it fits with very little...