2014

I was mowing a couple days ago and noticed my steering wheel was really sloppy, moved up down left right. After some research I was hoping that the bushings were shot. Tore it apart today and find a broken mount, looks like it's a very large part totally. Attaching some pics, has anyone had this...

Hello, was hoping someone could direct me to a video or a detailed description on how to remove the insturment panel. The lights on the left side are not working so I am going to see if it is a bulb that needs to be replaced. Thanks.

Looking for some advice on removing the rad from my tractor. Looks like I need to remove everything in front of the rad (oil cooler, battery and the tray that holds it all). Is that correct? Seems like a lot to simply pull the rad, but I can’t see any other way. Hopefully someone has a short cut...

Tractor has been running well, since I bought it. I have been keeping the fuel to it so it doesn't come close to getting low. My first question am I supposed to be putting some type of additive int the fuel or in another place on the tractor. It has the DPF filter on it and my friend says I...

Can anyone tell me the valve lash for this engine. I can't seem to find anyinformation on it anywhere Thanks

Hello to all, You guys helped me source this part sometime ago. thank you. But, just got this note after placing the order. Anyone know if there's another route to go to get my trailer wiring harness? Information below on what it is, and I need the one that includes the reverse back up...

I have a 2014 T4.85. The 3 point hitch will raise with the draft lever and with the hydraulic lift ground control lever (outside rear of the cab) but it seems the position lever will only raise the arms a couple inches. the arms will raise when i manually move the "linkage" under the cab that is...

Bought brand new in 2013 regen buttons worked fine the other day started it up pushed auto regen button lit up fine got the hay loaded turned off tractor bout one hour later started tractor to load more hay pushed auto regen button and it does not come on anymore. Looked through owners manual...

Hi guys, I'm in the market and this model has caught my eye. Its a 2014 with HST. This is listed as an interim tier 4 model. I am wondering does it have a computer that will need a special scanner to work out what is wrong or will I be able to work on it myself? What does it have in regards...

The 3 point lever has been getting progressively harder to move over the years, now requiring dismounting from the tractor and pushing with two hands. I sprayed what I could reach with some PB Blaster lubricant, but even then I ended up bending the lever pushing too hard on it tonight. There...

Has high flow only. How to make it use a low flow brush cutter?

I got my old 'n busted 2014 running for a while, actually ran really well, but then it started having idle issues, and now it won't start. Prior to quitting it wouldn't increase engine speed above idle without revving up for a second, dropping back to idle, and then it would eventually stall...

Dear Forum, My Jinma is basically dead. I get nothing. No lights, no start. The battery tests at 12.6 volts. I get the same voltage reading at the main fuse supply side. The battery is five months old I just replaced the iginition switch because I had panel light issues before and that...

Dear Forum, My Jinma has basically no electrical power. The battery tests at 12.64 volts. The same voltage reading to the 30 amp main fuse. I had trouble with dash lights before so I replaced the ignition switch (being careful to replace one terminal at a time onto the new switch). Didn't...

Hey Guys! I purchased a used 2014 5600 G-Series that I've been working on as it was overdue for a little love! This will be for home property use for myself, so it will also be a bit of a project to get it back into better shape! One of the issues that has come up so far, is that the machine is...