Search results

See my last post with results. Thanks

Solved!!!!!! I had a feeling when my joystick controller for my bucket was installed it was causing my 3 point hitch problems and I have found that it was. There was not an appropriate Power Beyond PB sleeve installed in my bucket controller so an appropriate amount of pressure was not being...

I think a lot depends on your mechanical expertise or need to know someone who has it to know what you are looking at and determining if it's a good value. My dad was a mechanic so I learned from him and have a pretty good handle on checking out all features of a vehicle before buying. My own...

CASH AND CARRY BABY!!

Ruffdog, I have ordered the PB plug from Summit Hydraulics. I'm going to install it which will disconnect it from the hydraulic block, Then I will connect the line for a closed center system hoping this will correct my pressure problem to the 3 point hitch. Thanks Dennis

Yes

Walter, it's a Front End Loader controller valve. Dennis

Thanks,I'll check that out. I'm pretty sure there is no PB sleeve on that port. It's just a step down sleeve. I'll do some checking tomorrow.

Hi Alex, no I said I checked the hydraulic delivery tube to the three point and checked for flow not at the PTO. Yes there is a pressure relief both in the 3 point and in the hydraulic block. I have had both of them out and replaced 0rings. I have the recommended pressure at the FEL 2375PSI Max...

Any suggestions?

Not that I have ever found on mine. Dennis

JD, did you get your loader valve hooked up? Can you send me a picture of which hose went where on the distribution block to where on the Loader bucket valve? Thanks Dennis

Yes!!

Found out down speed has nothing to do with lift. Unless it is "locked" in at a certain point. I have tried with the down adjustment all the way open and closed, no difference on the lift capacity.

Goes down fine. Holds weight fine, just won't lift any weight?

Yes, they will hold weight at any height, once lifted.

My 3 point hitch cannot lift any weight? It will lift it's own arms without any weight but if you only put your foot on it, it will stop lifting. The bucket works fine on the front. Here's what I have done so far: I checked the hydraulic pressure at the controls for the FEL and it was right at...

Thanks!!

Hello????????

Was this the pressure relief valve "in" the 3 point or in the distribution block? Thanks Dennis

Dave,do you have a couple of pictures of this hooked up correctly? If you have a three point hitch, is a power beyond sleeve mandatory? Thanks Dennis