Search results

Looking from front of tractor its standing up in upper left corner of engine compartnent. it is a large cap and unscrews. You will have to remove the overfow connection on side

All you need is Tractor Serial # https://service.mahindrausa.com/ssm/campaigncheck.aspx#

Have a new 3616 with just 2 hours on it.In MID and HI range when I steer right or left the ground speed goes down.The more I turn the more the speed falls.Going in a straight line up a grade the speed also falls.In all cases the engine is not strained-it is not changing speed.Is there an...

Getting close to 1st fluid change. Are any of Tractor Supplys fluid suitable for my 6500 4 wd with FEL. I will buy Mahindra if I need to but its much more expensive

Some additional pictures.

I just put a Wells Ag powder coated steel canopy on my Kubota. I chose the Well Ag (paid $400 at Kubota dealer)because I have had one on my Mahindra since new and it has survived many tree trimmings and 80 mph tows. I put the about 80 lb canopy on by myself using the Mahindra loader to do most...

With sides i won't be able to drive thru it. Attached is better picture. This is and far side is what I am trying to not stop but minimize rain blow thru but still be able to drive thru.

Attached is picture. Will look at suggestions and see if I can find good fit. Shed is 28X30 and on the 30 ft side I will install clear siding I already use on a carport.

The tractor set the height of the opening and I don't want to put doors on shed.. I am looking for a cost effective method of minimizing the rain that blows in (and we get a lot of it). I have seen the heavy hanging fingers of what looks like leather or rubber in industrial buildings that you...

Looking for smallest Skid Steer bucket I can find for my Mahindra 6500 4WD ML265 loader. The loader is made by KMW Loaders for Mahindra. Anybody know of a KMW or aftermarket bucket that will fit? I suspect 48 " is maybe smallest that will fit due to support arms but would look at any size...

Can't find my operators manual. Where do you check fluid level? What PS fluid od you use to top it off?

Every few hours my Joystick flops to left side. Dealer fixed it first time at 40 hours and, think heaven, showed me problem. It is now at 100 hours and I have had to fix it 4 more times. I have attached a picture. It is always this upper right hand turnbuckle that backs out and sometimes it will...

Had 50 hour service done. When I got it back noticed what looked like both filters were lesking. Called service dept and they agreed to give me 2 gaskets as I didn't want a 60 mile round trip towing tractor. Of course Mahindra only sells gasket with filter so they gave me 2 filters. Got home and...

Been meaning to ask this for a while. Got my 6500 last year and while it does have a glove compartment door it has nothing behind it! When I open it I can put my hand threw it and out the bottom, i.e.- it won't hold anything. Is it supposed to be this way?

35 hours and even with a light weight rear attachment like post hole diggers without auger (maybe 220 lbs) it will drop about 1 ft per 2 hours. FEL is fine. Can find no leaks and fluid is good. Any thoughts?

Bought new tool box from Tractor Supply 3 months ago and finally installed it today. Was able to just remove 2 rubber stops and used 2 existing 5/16's threaded holes in fender and drilled 2 more at far end of box. Used neoprene washers between toolbox and fender to isolate the box from fender...

Just bought a 1080 but need close up picture of Engine fuel injector pump. The linkages have been taken off and I need to know how to connect. A clear picture is not in I and T MF 1080 Service manual

Just bought a 1098 that had ran out of fuel. The diesel runs out of primary and seconday filters ok when I manually pump fuel pump but I can't get it to come out of low side or high side injector pump. Any thoughts on problem?

Anybody know any aftermarket filters like NAPA, Fram, AC Delco for 6500's?

Bought it new in May. Back to Dealer in June for leaking seal and "lope". They said no problem but when I picked it up they said that the "lope" was normal. It's not bad but when doing critical work it's a pain. Anybody know how to cure? Tractor has 9 hours on it.

To much HP for one. Already bent a new 3 pt Howse Middle Buster attempting to dig a water line. This Texas clay is really tough! Having a new 30X40 metal building going up and the 42 ft flatbed weighting 22 tons got stuck delivering steel. 1400 rpm low gear in 4WD and out he came. The SKZ 165...

Tired of spinning wheels on my 5005 DI. Bit the bullet and ordered a new 6500 4WD with FEL. Have option to get the Quick Attach for $585 but don't use a hay fork (at least for now). Should I get it anyway? What else can you put on front ?

I currently have a 5005 DI.How much tiller can it easily handle in Texas Gumbo clay soil? If I go to a 6500 4WD?

I have a 5005 DI with a ML214d loader. In a search of the newsgroups I found someone that said the ML230 is later version but looking at ML230 spec it's a 60" loader and my ML214d is a 72". Looking for operator's manual and what is considered modern version of ML214d?

On the power steering reservoir it says use automatic transmission fluid Type A or F and gives Dexron II as example of type F. My 2005 DI Operators manual says Dexron III. Whats proper fluid?

Do a search on Mahindra key and they will come up. Only a few available. $2.49 each which includes shipping. I just bought 2 from dealer at $17.

Anybody been able to match an aftermarket paint to Mahindra color?

Mahindra no longer has them. Looking to buy one or pay for photocopy. If you have one I can "rent" for a few days I will scan it in. Send me private message. Arnold Williams

Bought a used one with no manual. What is API rating and weight for engine oil for 5005 DI? How about proper hydralic fluid?

Anybody tried an after market canopy for Mahindra? If so who and were you happy with it?