Search results

I have a TYM 554 and I am on my third dash. The screen would just gradually start going black and you could not read anything on the screen. First replacement was under warranty last one which is a new design was around $500.00. I was at dealer once when a new load of tractors were just...

It is 6ft cutter and I think after the wheels run over the grass the grass is still lying down before the cutter goes over the grass. I even overlap most of time but there is always a strip that springs back up.

This is not about haying but did not know where to put it. When brush hogging my field is there any way to keep the grass from springing back up where the back wheels of tractor has pushed grass down. The cutter covers the width of the tractor???

Dealer found the mice had chewed some of the wires. Repaired that and codes went away...

Few years ago TYM was at the big boy table. When RK came along TYM was moved to the other tractor brands...

My T554 PTO seal started leaking. Had it replaced by non-dealer. Later I was talking to the dealer about it and he said I will tell you why the seal went out. He said there is a vent hose hanging down near the PTO, and dirt dobbers plug up the hose and this will cause the seal to fail. I went...

Thanks

My dash shows these flashing numbers and can not find out what they mean. SPN: 51312 and then flashes SPN: 366688... Below these numbers shows FMI: 4....

Anyone using EFI and if so how do you like it? Is it better than a carb.

Have not contacted dealer. Put oil on it but still would not move. Thanks......

Have TYM 554 and lift arms will not raise the brush cutter. Attempted to move the draft lever but it will not move. How do I free the lever up.

Found the trouble. It is a bad ignition switch. Took wire off the switch and touched the wire to battery and tractor started right up.

I have had the tractor for about 35 years. Been good tractor. If battery is up it always starts. Took the wires to the neutral switch off and touched them together and would not make a sound.

Would not turn over with clutch depressed

Will a bad neutral switch on MF 135 cause motor to not turn over.

will bad neutral safety switch cause engine to not turn over

I ended up buying a Delco battery, and was looking at it when I got home and it had a stamp that stated Made In Korea.

I have a 55 hp TYM that has an Interstate battery that has lasted little over 7 years. (pretty good). I realize that there are only a few companies that make batteries and they just put the various name brand on the different batteries. Just wondering which battery seems to be holding up the...

Something to think about. As a long time law enforcement officer (now retired) I always hated when people left the keys in their vehicles. If we were in a veh. pursuit and the guy wrecked, and then ran off into the woods before he could be arrested all he had to do was wander around until he...

My paper is delivered by the USPS. Lucky that the paper got here in a week.

Just read in the paper where The Toro Company purchased the Intimidator Group. The Intimidator Group makes the Spartan Mowers and several other products.

I think TYM now owns Kukje.

Tractor Supply has a fuel container that will empty 5gal in 60 seconds. Have one and it works well. It is called Fuelworx-part #47906-c1 SKU 135830399. Price is 39.99.

Here is your Arkansas answer for securing hay. Go to www.ahtd.state.ar.us Click on publications and scroll down to Motor Vehicle and Traffic laws & state highway commission regulations ( ACT 300) The Act 300 book is considered the "Bible" for enforcing the traffic laws in Arkansas. In...

Has anyone tried the self-sharpening lawnmower blades. Posted in lawn and garden section several days ago, but got no response.

My son was using our fairly new Dewalt 40V string trimmer in some tall grass, and the grass wrapped around the shaft. He just kept using it and it apparently burned the motor up. Can the motor be rebuilt or would it be cheaper to junk it.

Have T554 and went out to cut the pasture and the PTO would not engage the cutter. Have not used the PTO since last fall. Where do I start looking?

Something that would be helpful to many of us is to include the BRAND of the of the tractor or equipment that is being referenced. Many just post a model number and think everyone will know what model number belongs to what tractor. I know many of the brands, but sometime someone just puts a...

Any advantage of EFI vs Carburetor on zero turn mowers...

My neighbor has a 15 ft., model 1815 rotary cutter he purchased used, and the center section cuts about a foot higher than the two sides. He says the blades are on correctly, and the JD dealer does not know what is causing this. Anyone know what could be wrong?

Is there a height adjustment on the automatic PTO setting? When I have the cutter running on auto and raise the cutter only slightly the pto goes off. When on auto have to have the cutter so low that grass builds up in front of the cutter, and makes a big clump grass. I then have to raise...

Is Dixie Chopper going out of business?

Anyone know what these symbols mean on my dash monitor. SPN:0 and under it FM1:0 The symbols flash on and off..

Not really about tractors, but why is it so hard to find insulated coveralls(in my area). One farm store said they had been attempting to get Carhartt's coveralls for 2 years, and still have not received any. Gone to many stores and they do not have any. Walmart did not have any in the...

What is everyone's opinion of which brand of anti freeze is best (for 99 Chevy pickup) and for the various tractors. Are all the brands about the same?

Just saw where Rural king stores are going to start selling tractors with the R/K name, but made by TYM. Their prices look good. May be a good place to also get needed parts..

Have T554 with about 30 hours. When the steering wheel is turned there is a slight whining noise, and when first started the wheels are very hard to turn. After moving the tractor a few feet it steers normally, but still has the whining noise. Fluid levels are normal. Dealer is coming soon...

Just as I started to turn off the my T554 after some brush cutting, I turned the steering wheel and the tractor made a whining noise like when your car is low on power steering fluid. Went ahead and stopped the tractor, and when got back on today it still made the noise and the wheel was very...

Anyone know what size wrench it takes to remove the neutral safety switch on the massey 135? Is it standard or metric size?

After looking at many brands of tractors I purchased a new T503 today (with loader) for $22,000.00. The price included a heavy duty front hay fork. Dealer said $500.00 less if did not want the hay fork.. The TYM had many more standard features than the other brands that I looked at. Also...

Just joined today, but have been reading posts for awhile. Have an old old old Massey Fergerson 135. It always starts, but I would like to have a new tractor with a FEL. Don't really have to have a new one, it's just that I would like to have one before I get to old to enjoy it. Been leaning...

First post, but been reading for a while.. Do not know much about kioti tractors. Are they good tractors? Plan to use for light mowing, and maybe a little FEL work. Only have a 16 acres to keep up, but have another 125 acres that are presently leased that I may have to take over someday...