Just another junk chainsaw

[JeepHead]

@JeepHead I'll let everyone know in my group and you here. But some day there is going to be a clone of the 346/353.

Not that I care anymore being I love my echo 501's etc. I'm all set now.

But will make it easier for guy to get parts etc.

It was a PITA to find stuff on that project packrat 346 OE. It is running a aftermarket 44.3mm topend on it testing. Only off of oem time wise by about 10%
If I didnt know it anyone would be happy. Another guy ported one and said they port up good too.



View attachment 3854700View attachment 3854701View attachment 3854702

That will be a HOT seller!

 

[xyz123]

That will be a HOT seller!

Yep several guys waiting.

Just top covers etc alone is drying up and people want stupid prices for parts. Let alone a whole oem saw now days.

I used to buy new ones cheaper then guys selling new ones for now days.

Case in point 2 I bought new in NE 50cc.

 

[JeepHead]

Yep several guys waiting.

Just top covers etc alone is drying up and people want stupid prices for parts. Let alone a whole oem saw now days.

I used to buy new ones cheaper then guys selling new ones for now days.

Case in point 2 I bought new in NE 50cc.






View attachment 3854732View attachment 3854733

Imagine what a NIB 346/353 one would sell for today!

 

[xyz123]

Imagine what a NIB 346/353 one would sell for today!

Seen them listed before as guys stuff them back.

Some want double to triple. No thank you.

 

[xyz123]

Guy from Romania in my group. He went unlimited coil and ported it says.

 

[xyz123]

Aftermarket coils for a kohler command twin came in. Going to see how long one last. 2 for 25 or 1 oem 98

 

[xyz123]

Translated to English

 

[D'oh]

Guy from Romania in my group. He went unlimited coil and ported it says.

His Plug looks like he could lean it out quite a bit. Not sure what this Unlimited Coil means, but I assume no Rev Cutout, so at 14,000+ not sure if Leaner would be better.

But a 14,000rpm cut out and leaned out would shave more time off his cuts.

 

[xyz123]

His Plug looks like he could lean it out quite a bit. Not sure what this Unlimited Coil means, but I assume no Rev Cutout, so at 14,000+ not sure if Leaner would be better.

But a 14,000rpm cut out and leaned out would shave more time off his cuts.

Thats what he was showing in steps before adding a H to the carb to turn it down. The plug at end is after riching it up.

14 without a H side is lean.

12.3 was getting close on my oem one way back without H and unlimited coil. To being lean.

I'm watching mine G3120 clone now to see where it goes. I put a unlimited G395 coil in it to test out with stock no H carb.

I have a H side clone carb too if it is needed.

 

[xyz123]

Pushing down hard with 3/8 8T testing