How do these come apart? Replacing the rear glass and need to disconnect the strurs feom the glass brackets so I can install them into the glass without having to try and keep the entire assembly compressed while doing so.
L6060 rear glass struts disassembly?
- Thread starter jk96
- Start date
- Views: 1819
-
- Tags
- glass kubota l6060
bdhsfz6
Elite Member
- Joined
- Apr 11, 2015
- Messages
- 3,149
- Location
- Northeastern Pennsylvania
- Tractor
- Kubota MX5800 HST & L6060 HSTC Formerly L6060 HST B7100 HST, L2550, L3010 HST, L3430 HST
Here's a you tube on how to do it. Removal is shown at :57
RustyA
Platinum Member
Hang on to the clip, they like to go flying if pried too far back.
Gord Baker
Platinum Member
Do NOT attempt to keep them Compressed. Open the glass Fully then disassemble per instructions below.
charlessenf
Gold Member
Those little spring clips slide off - then the cylinder pops off the ball stud(s). If you stop into an auto supply store (or similar) they may have a package you can open to read the R&R instructions. Also, look for a YouTube on Removing Gas Operated Struts
"To remove a gas-operated strut, you'll typically need to release the mounting clips or fasteners at both ends of the strut, then carefully detach it from the mounting points. This often involves using a flathead screwdriver or a tool to release the clip and then pulling the strut away from the ball joint or mounting bracket. "
