Recent content by tsmithco

What wheels exactly do you have? I've read through this post and it wasn't clear to me. I've got to replace my front wheel on my L5740 and want to upgrade. (1 is factory and 1 is a Titan HD 2000) so I need to switch them both out - not sure why the previous owner did that!

I've got an L5740 with the loader, and I've noticed that last couple months that the bucket has some slop in it while driving. For instance, when I hit some bump, the bucket can flop forward and backwards a little. Additionally, it will slowly drop down even while the tractor is running...

Both of these are indeed the "work lights" as they are connected to the work light fuse.

Thanks. No air ride here! but would make sense for cab models sharing the same bottom. I didn't find any work light wiring under either fender - just wiring for the turn/hazard lights, and the rear tail lights. I'll check again on that right side to triple check.

I've got an L5740, and There's 2 green wire harnesess under my seat. Both appear to be powered 12v when the key is on. What are these for? What are they fused at? I'm looking to add an LED lightbar to my ROPS, and wasn't sure if I could just use one of these, and switch it for my lights - or...

So I took the seat off, and removed the underside plastic cover (a surprisingly difficult task as the screws were rusted in - I had to use an impact screwdriver). I removed the sensor (which also broke the bolts holding it in place because they were rusted in so bad they just snapped after 2...

Looks like I have 2 switches, with 2 wires each. 1 switch is a plunger style that is under the seat, and theres 2 more wires travelling into the actual seat itself. From reading, it seems like the plunger switch under the seat is for when I want to use PTO while not seated, and the sensor...

Good to know I’m not the only one. Come daylight tomorrow I’ll investigate.

Only at that time. Later it was not fine

I was out working the tractor hard clearing brush and honeysuckle with my root grapple on. About 1 hour in, I'm working an area that's facing downhill. Seatbelt on and being very careful to not tip. At one point, I went to backup and the engine tried to stall. kept doing it. I set the brake...

Thanks all.. Yeah, nothing crazy, just those attachments. no plowing dirt or anything like that.

I was looking at quick hitches, and rural king, tractor supply, and harbor freight all say "for tractors no more than 45 HP" fro the cat 1 hitches. Why? I have 2 tractors - New Holland TC33d (33hp), and a Kubota L5740 (57hp). All my attachments are cat1. - box scaper - 84" flail mower -...

I've got a L5740 and I normally move round bales around without issue (prob 1k lbs). However, I'm looking to get some rubber arena footing in 2000lbs super sacks. They can send on a semi with or without a gate. I keep a barrel filled with concrete on the 3pt as my balast, as well as fluid...

Couple problems. I've having to empty the bowl about every month or so. Somehow, water is makign it's way in, and obviously, when it gets to a point, the tractor loses power and stalls. I can't figure out how it's getting in. The tractor does live outside unfortunatly, but everything looks...

I'm upgrading, and selling my Yanmar, but I can't seem to find anything online, etc to determine what asking price I should post. YM 2020, 1075 hours (around mid 1980's from what I could find) 2WD Turf tires, and Rice lugs (1 set of each) 72" King Kutter Finish Mower Bush Hog Front End...