number two's latest activity
-
NI don’t have access to you model of machine. However, it’s not hard to convert inches to mm. Multiply the length value in inches by 25.4.
-
NWithout doing much research on the G5200, I took a gamble on one today for $1300. It has 1235 hours and looks better in person than it...
-
NYou need a new small tank and a Cycle Stop Valve. Check here: Constant Pressure Pump Control Valves
-
NTurn the pump off, and shut the valve from the pump to the tank. Drain the tank of water. Then pressure up the tank with air via the...
-
NI don't see how you could hurt anything by trying that. I would. I also like having an excessively large pressure tank in case the...
-
NNow would probably be a better time than later to replace the pressure tank if you can't get the water out of it. Eliminating it would...
-
Nnumber two reacted to pmsmechanic's post in the thread Balky (rusty) tailgate latch on GMC pick-up with
Good Post.
As a part of every oil change I lube all the vehicle hood, door, trunk hinges with WD40. Also all the door, hood, trunk and tail gate... -
Nnumber two reacted to JDW 1's post in the thread 3pt broadcast seeder that can be run from cab. with Good Post.
I have a herd seeder and went to the auto parts store and purchased this truck PTO cable. It works fine to adjust on the fly and shut it...
-
Nnumber two reacted to Shawn T. W.'s post in the thread How do you clean your greasy loader pivots? with Good Post.
I use that Dawn Platinum Power Wash shown above on the exhaust on the underside of my loader arm where it points when the bucket is flat...
-
Nnumber two reacted to chim's post in the thread How do you clean your greasy loader pivots? with Good Post.
Every few years when there are big globs - I don nitrile gloves, grab a roll of paper towels and a wooden paint stir stick. The wooden...
-
Nnumber two reacted to Lineman North Florida's post in the thread How do you clean your greasy loader pivots? with Good Post.
I immediately started laughing when I read your response as I can't count the times that I have turned a nice shirt into a work shirt by...
-
Nnumber two reacted to tacticalturnip's post in the thread How do you clean your greasy loader pivots? with Good Post.
As I said on GTT, I clean the excess grease off of my tractor by wearing my best shirt near it. It is guaranteed to work every time.
-
Nnumber two reacted to mikester's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
+
-
Nnumber two reacted to dodge man's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
JD says every 10 hours for the FEL. I always remember a contractor, who I assume their maintenance people got tired of fixing stuff...
-
Nnumber two reacted to JenniferKubotaM62's post in the thread Anyone bought or priced a new Kubota L47 or M62 TLB recently? with Good Post.
The M62 being a purpose built tractor loader BACKHOE, the backhoe subframe was engineered into the tractors from day one, is the MX the...