My tach will start working after my tractor has warmed up but not before. It will continue working if I shut it off and start it again. Any ideas on this?
Mark
I replaced my gear shift 1st and 3rd are under the seat. I have it so it curves back toward the seat. I'm not sure but I think my other 1 was the same postition but it didn't go under the seat in 1st and 3rd.
Mark
My engine started making a clanking noise (the best I can describe it). I don't know what a broken rod sounds like but I thought that might be a possibility. It's a Jinma 284 LE and it has 475 hours on it. Ran fine until this happened.
Thanks,
Mark
As you are sitting on the tractor my left 3 point arm is leaking. I have the arm off and also the back. Does anyone know how to get the bushings in and out?
I have a 3 point lift kit to put in does anybody have that process documented
As you are sitting on the tractor my left 3 point arm seal is leaking. I have the arm off and also the back. Not sure how to get the seal out. Also need to put in a 3 point lift kit. Read somewhere someone used a screw attached to a rod to pull it out but couldn't find it. I couldn't get...
My water pump went and I replaced the water pump and thermostat. Before my water pump went out the temp gauge read about 70 even when mowing. After cleaning, flushing and refilling I started it and no matter how long it idled the temp wouldn稚 get above 50. When I start driving and mowing the...
I was using my tractor the other day and had it parked and running and antifreeze was leaking out. It was not leaking around the hoses or thermostat. I think it's the water pump but didn't know when that went out if it would leak like that.
Mark H
I made a new post because I thought maybe people thought I was listing cross references but I have a problem.
I found these cross reference numbers on a couple of different sites.
Oil Filter - NAPA 1516
Fuel Filter - NAPA 3195
Air Filter - NAPA 2276
I was changing oil and the filter doesn't...
I found these cross reference numbers on a couple of different sites.
Oil Filter - NAPA 1516
Fuel Filter - NAPA 3195
Air Filter - NAPA 2276
I was changing oil and the filter doesn't fit. I went to NAPA website and it says Oil Filter Thread Size (inches) : 3/4 - 16. Any help would be...
I shut my tractor off out on our property and it wouldn't start again. It didn't turn over there wasn't even a click or anything. The last 3 or 4 times I started it it turned over slower than normal.
I was able to start it by jumping across the starter so I brought it back to the house. I...
This is similar to another post but I didn't want to cut in on it. When I try to start it it only turns over a partial turn. I can get it started using the decompression lever.
I have a new battery that I know is good. I have cleaned all the connections.
Mark H