Recent content by kjg26

The 3 piece bar kit you refer to.... it's that factory stuff from the ezgo top?

I have a kioti DK55 ROPS. I've made a cover out of a gold cart top. I'm wanting to install a radio and speakers. Im thinking marine stuff should do fine. But do I need to have then in any sort of enclosure or can they be just mounted ?

I have a titan implement 1306 cutter that I believe the clutch has gone out on. Anything other than light grass just doesn't cut and sounds like I'm loosing blade speed. The clutch gets super hot too. Where can I find info on replacing the clutch disc's as well as the specs for the bolts etc.

In what situations would you use this slotted portion on the lower link lateral stabilizers (unsure on actual name) mostly use my 3ph for Bush hog. Have a auger and box blade (which I've yet to use) as well.

I'm sorry. I thought I had posted this picture. The roof runs perpendicular to the side of the house that I'm working with. Cost and ease and installment is the biggest reason. Also structure is sound level. It will remain as it is for the foreseeable future

So in these very basic, and not to scale, drawings you can see the lean to shed from one plane. The length or depth of the shed is dependent on the height because of the roof overhang that i'm working with. The taller the shed is the narrower the roof line is. I don't want to go any less than...

When cutting the back pasture my 551 keeps getting hot. I turn off the PTO and let it idle for 5 min and the temp goes back to normal. Lasts about 10 min then get to repeat the process. 6ft bush hog. Medium range and in 4th gear. Happens slower if I'm in 3rd gear. Grass is about waste high...

On our property we have an old house that had a fire in a portion of it. The house is unusable and will eventually be torn down. I am looking for some additional covered storage out there. I was planning to put a lean to on one side of it. I am new to this type of building but am good with my...

I'm looking to purchase a set of forks and. Hay spear. Or a combo. Or just forks. At this time I'm having someone cut the fields for hay but I'm having to move the bales. So my first thought was... hay spear....then I thought a set of forks would be useful in countless ways...then I stumbled...

I know this has been discussed somewhere before but I cannot find it. I am coming up to my first maintenance on my new to me DK551. I need to get air/oil/hydraulic/fuel filters. I have the part numbers but am having a hard time finding vendors online. I found tractorjoe but that is...

I've been unable to find the type of tip/teeth that it came with but I have found these. It was suggested to me that I can drill a second mounting hole and it will work just fine.

I purchased a post hole digger and two auger bits 2nd hand. It's apparent that they need the teeth replaced. Im going to try and attach pictures of how my bit is set up. Where do i get replacement points and teeth?

I just purchased a low hour, 72, Ikon x 52" zero turn. It throws the drive belt as soon as the engine is on. Otherwise it is in excellent condition from what i can determine. Where do I start in troubleshooting this? The pulleys all appear to be in line and the belt is tensioned to spec. I...

Probably a dumb question. I have a Kioti DK551 that has Cat 2 arms on the rear. My brush cutter is Cat 1. I am using reducer bushings on it. The brush cutter attachment points are set up in double shear. The bushing always seems to wander out from under the link arm and doesn't do its job...