Recent content by Kioti Dave

  1. Kioti Dave

    First regen

    Agree with RjCorazza. When I mow, the rad always get plugged up. On my kioti, regens average about every 30 hours depending on the type of work I'm doing. (Now at 1000 hours) I record the hours at every regen. When one injector went bad was doing a regen every 2 hours. I always just...
  2. Kioti Dave

    Opinions on NX4510

    I have an 2018 NX4510 HST cab. Bought new. Had some early problems that were sorted out on warranty. Now have 1000 hours and overall am very happy with the tractor. Not sure what the HST problems are, but mine seems to function fine. I like the size and weight of the frame. Loader is a...
  3. Kioti Dave

    NX4510 CEL (check engine light) on and can't turn off

    Will do. Having a hard time paying the dealer to send someone out to just clear the CEL. Probably a couple hours with the travel time. Just hit 1000 hours and despite a few early problems, the last 600 hours have been without any issues. (had an early main seal leak, bad injector and turbo...
  4. Kioti Dave

    NX4510 CEL (check engine light) on and can't turn off

    Thought of that. But it's been 25 hours since, and everything seems to be working normally. Guess I'll just need to have dealer send out a service guy.
  5. Kioti Dave

    NX4510 CEL (check engine light) on and can't turn off

    Yea, already tried that. Thanks for the input.
  6. Kioti Dave

    NX4510 CEL (check engine light) on and can't turn off

    Had a coolant hose come loose which set ofF the CEL. Reattached hose, filled coolant and now still have the CEL. Anyone know how to turn it off without the dealer?
  7. Kioti Dave

    Gear oil for rotary mower

    I buy one pail of gear oil and use it on all my gear boxes. Can't see it being a problem.
  8. Kioti Dave

    Rear remotes for backhoe

    My NX4510 has 2 rear remotes. Neither has the float function. Can I run a backhoe from these remotes that don't have float function?
  9. Kioti Dave

    3 point

    There is usually a valve just below the seat that is used for adjusting the rate of descent for the 3 point. If you close that valve all the way, the 3 point will not go down. Could that be from that valve??
  10. Kioti Dave

    Ballast NX rear wheel weights.

    How much did you pay for the weights if you don't mind me asking. They were tough to install??
  11. Kioti Dave

    NX4510 vents oil from remote valves

    Ok, so could the valve not be working correctly? I have 2 rear remotes. The bottom one is hooked to the top link and never seems to leak. The top remote leaks no matter what I hook up to it. If I lower slowly, the leak is minimal. If I lower quickly, more fluid seems to come out. I will...
  12. Kioti Dave

    Bent loader mounting plate

    Know someone with a press?
  13. Kioti Dave

    Upgrade from CK2610 to DK5310?

    Lol, guess you are right. 😊
  14. Kioti Dave

    1st time buyer - 35 hp comparisons

    If you are able, driving each tractor on the lot would be worth your time. Each tractor will feel different and some issue you never thought of may show up. For me, I owned a 30hp Kubota for 15 years when I upgraded. I don't like the single treadle peddle on the Kubota. I very much like the...
  15. Kioti Dave

    Upgrade from CK2610 to DK5310?

    I went from a 30hp open station B7800 to a 45hp cabbed NX4510. I do work in the bush and the size difference does make maneuvering in the trees more difficult. If I am only using the mower in the trees, I either take the bucket off or the entire front end loader. That helps a lot. I also...
Top