Recent content by ipegasus

I have a New Holland Powerstar 75 that I purchased in 2019. I am the first registered owner. Some say that I should call it a 2019 as I am the first owner. I found a sticker on the engine that it was produced in 2017. My purchase agreement did not state a year just the model.

I had a 2 wheel drive, open station International 2500B for 24 years. I did use it in the winter blowing snow, it was cold and the snow blowing in your face was not so much fun. I now ha a NH T4.75. I am very spoiled now, it is so comfortable in all weather conditions,

Check this one out. I purchased one about a year ago and am working on my TIG skills. So far the unit has been flawless. High quality accessories too. https://primeweld.com/products/tig-225x-ac-dc-tig-welder

Cab for me. These pictures tell the story of comfort.

Here is my solution of moving trailers or implements with a draw bar connection. Just raise the loader up and you have access to the hitch, stays on all the time. Never have to find a spot to store the hitch plate or the bucket.]

I realize that NC is a temperate climate compared to the Midwest. Here is why I really appreciate a tractor with a cab, heat and air.

I have spent many years snow blowing with an open station tractor. It's been cold and the snow blowing back in my face just has not been fun. A heated and cooled cab was the way to go. Here is a picture of my indoor/outdoor thermometer inside the cab.

Here is my front mounted hitch. They are great for moving things into tight spaces. You have much better control over a rear hitch.

The plastic mounting tabs that are suppose to hold the boot to the console appear to be too short to grip well. Or else the hole is too big. Anyone else have this problem?

Here is what I have for moving snow. 84 inch blower on the 3 point and a 84 inch snow bucket on the front. It does the job nicely.

I purchased a new NH T4.75. My warranty started as of 2/1/19. Does that make my tractor a 2019 model? The serial number plate on the engine shows that it was made 7/17. When the engine was made may not have any bearing on when the tractor was assembled. My previous tractor was an...