Gordon Gould's latest activity

My dad had an old Mall 2-man chain-saw, 4-cycle engine. To saw horizontally, the bar pivoted. I was the helper when I was 10-14 years...

We were back on the job yesterday, here's the two tractors, both have 3 cyl diesels in them, SO, when you park them inline, does...

The wood/dirt pile I've been working on. They bulldozed a fence line full of hedge 20+ years ago and pieces are everywhere. I burned the...

I was honestly quite concerned that the thing was going to fall on me while mowing. It was hanging so low that I had to go around the...

New project. Hate to do it because it's a pretty tree, but this sandbar willow is finally starting to give up. I think it was 4 stems...

I like odd growing trees like that Runner. Your a better than than I working in that weather. We had mid ninety's here yesterday too...

When I went elk hunting in Washington state, I was impressed with their mountain roads. the roads were canted into the side of the...

I was trying to figure out why they seem to cost so much and decided to put my own "kit" together. Looks like the tractor in question...

I bought a top-n-tilt kit from FitRite almost 10 years ago originally for my Kubota B2910. For various reasons I never installed it on...

I think it depends on how much the generator pulls torque-wise on the PTO, and the tractor horsepower. My generator is a 30kw, and I...

Nice set-up ! This is off topic but I am curious as to how much fuel you use, per hour say, running a rig like that. I realize it...

I used one of those to mount my PTO generator on. Welded on a roof to keep the rain off the generator itself, and legs to set it on the...

My dozer sits in the woos. Never got wiring chewed - knock on wood - but the dash board box and the battery box were always full of...

I beefed up the pins on mine after bending the up rights in the pin area going thru a hole to fast. This is what I did but I like...

That looks like it puts a lot of force on the welds at the joints between the uprights and the lower arms. Here's what mine looks like...