Recent content by fbson395

  1. F

    Close to starting my Workshop

    Just got the permit to start on my workshop.Having the cement work and most of the building contracted out. To cut the cost I left myself with some finish work. 1.I have to install the windows and doors . 2. Put the lap siding up and paint the exterior.3. Have to run a 100 amp service from the...
  2. F

    Metal Building

    Could use some advise as to the purchase price and what to LOOK OUT for on the buying of a 30X40X12 metal building. I have one Quote so far for 15K for the building and 9,800 to put it up. The cement floor and footings 7k. What do you TBN's have to say, is that priced about right? How hard would...
  3. F

    WON'T START

    My L245DT was at a Idle, it started to sputter and died.I checked the fuel and it was empty or just very low, to dark in tank to see. I added fuel and tried to start it. Won't start! I removed the fuel line from the fuel filter to the injector. No fuel comes out of the filter i assume it is...
  4. F

    Help with Block heater for kubota L245DT

    Hello, Hope that everyone had a good T-day. I have a question about block heaters . I would like to install one on my L245DT. The question is about which type to install. The Magnetic type from what I have read does not do a very good job of heating and one review said he needed to remove it...
  5. F

    Power Steering for L245DT

    Hello to all, Well, It's been a few months since I received all the parts to install Power steering. All the parts are in and now I have no Hydraulic pressure. Now I have to wait for a new pump from a guy on ebay. I seen the thread power steering in 90 min and that is what Im doing.Here are a...
  6. F

    ROPS for older Kubotas

    Hello , I'm sure many of you know of this program but This thread is for them that don't. Kubota sells ROPS for many older models for about $148. To see if your model is on the list check their web site. When I called the dealer they checked into it and said that the price was $148 and that...
  7. F

    L245DT how much SAE80/90 gear oil for front and rear on 4x4

    Can anyone tell me how much gear oil I need to replace in both the front and rear of my axles. I'm replacing all the seals and bearings but I can't find any specs on how much oil each unit takes. It takes SAE 80 or 90.Thanks. Someone out there will know. I live far from town and don't want to...
  8. F

    Need Help from All L245DT Drive Train?

    Need advise as to what would cause my left rear tire to stop, as in something is hanging up. This problem just started, Not sure as to all that is going on yet, but their is a noise from the left rear axle area and the wheel stops. I shifted into reverse and it cleared it? Somewhat,Sounds like a...
  9. F

    What is the function of the Differential Lock

    Hi, Since I'm new with my tractor. What is the function of the differential Lock? When would one use it? No such thing as a stupid question, Is their? I'll Listen!
  10. F

    power steering for L245DT

    Hello to all, Can anyone tell me how many GPM a power steering gear box would need to operate.I purchased one from a B7800 and plan to use it on my l245. I know there will be many modifications. Just want to be sure I get the needed flow. Might be better off to purchase a kit. But I like the...
  11. F

    Power steering for Kubota L245DT

    Looking for anyone that has added power steering to their kubota L245DT. Does anyone make a kit or will I have to make up unit form auto parts?
Top