dusty3030's latest activity

So it is a no-go for having the correct adaptor. It would be nice if somebody could identify the diagnostic plug Kioti uses. I suspect...

Don’t know about running a 36” on it but I love my Echo cs620 running a 24”. Great rugged built saw for the money.

Another Kubota hay baler owner/operator on another site I frequent thinks his Kubota hay baler is far from "hands free"!

You constantly throw shade at anyone who runs a baler with knotters, calling them “idiot bricks” (like we are idiots for making square...

An "open center" hydraulic system circulates all the fluid the hydraulic pump is pumping through all of the control valves until a valve...

I've used the Nest thermostats at home and for away from home properties for years. I'm not thrilled Google bought them and...

Wrong. They’re both diesel rated oils, intended for diesel engines. You can run either in a gasoline engine, if that’s what you want

Wrong. Even the OP’s second post already stated he’s in physical possession of 10w-30 T5. You can also get T6 as a 10w-30

Conway or Loretta is fine with me. Lots of this new fangled country "music" is just rap to me. I was just gonna remove the interior...

If it does it won’t pick up nothing newer than Conway Twitty or Loretta Lynn. Can’t wait to see before and after when this thing sucks...

You’re probably the only one on the website who has taken one of those off. Did you figure out your no start? I think I’m going to send...

If the OP would jump the ground wire on the start relay to ground he can hop in the seat, start it up and drive it on the trailer.

IIRC using a bar to turn flywheel on this model JD is very difficult. Hole to access flywheel teeth is on the RH side of engine.

Previous thread that might help. https://www.tractorbynet.com/forums/threads/nx4510-starter-not-turning-over.443159/page-2

All the safety switches are controlled by a module on right side behind seat behind a panel. They had some bad modules in that time...