Recent content by DLTrekkers

It can be brakedisc material that you found . With the 1st oilchange was the oil milky ? Water dissolfe that (glue)

You need a spesial tool to instal them to the correct depth

5/8 unc by 11/4

Needs a special tool to fit that seal. It comes in 2 parts . The seal and a wear sleeve

Switch on but do not start . Check on pad for a little red light blinking . Count those blinkes to get the code.

I found that the ground wire dose corrod. Lengtern that cabel and ground it direct to the engine.

So the solled shaft stay in the pressure plate ? Loosen the pressureplate and remove all.

I have learned that a newer oil covers the older ones specs aswell !

And to assist with putting everything together use a come- along lightly !

Brakes are fine, just replaced them last week.Did you do as I said ? Without the gasket....then with the gasket ?

What airfilter was installed on that tractor ? A drie airfilter or a oilbath ? If you overfill an oilbath just a little bit it will suck it into the engine.

Brakes...essemble the finaldrives with everything exept the gasket .tie up everything...then remove finaldrives and install again with the gasket ...then brakes will be ok !

6 sil diesel toptorque and valve clearence please ?

Very old...

It was in a truck but now in a tracktor