dicktill's latest activity

I just wanted to update on this. I had the tractor serviced by Bell Meade Garage in NJ. It turns out that the prior owner had put one...

Would seem to me and my limited knowledge of hydraulic that looking at the whole system is sort of blinding the OP and others.... Sort...

A follow up after my first reply.....I did more research on-line and found this..... In the new study, Arizona State University...

Raccoons shiit where they sleep. Dilution isn't the solution to pollution

Can they both work in float at the same time? What brand?

I can attest that the Bucher valves are top notch. And if multiple floats are important to you, you can do that with the Bucher valves...

Yes, you could. Would need longer bolts later however. These are Bucher valves, top of the line stuff...

Back to my "befuddlement", etc.: You've had this stuff taken apart previously. I think you need to trace all your lines against the...

I have heard this before, and it's how I got the mistaken impression there were two hydraulic pumps.

Look again at the link I provided above for the GC hydraulics. The backhoe valve is shown on that. But be sure to scroll down to the...

I am befuddled about this event! It makes no sense to me considering the way that the loader, backhoe, and 3-point valves are plumbed...

I too, just saw this -- OUCH!! I am glad to read that you have a lot of warranty on her. It's just going to be how much time does the...

You are 110% correct that an HST in a stall going over the work port relief will get hot very quickly. That is why the more expensive...

Hmm. Looks like I've been using my tractors wrong, always doing my very best not to spin tires. Maybe that's why their tires last so...

On an HST the high pressure work port reliefs relieve the flow to the opposite work port not the reservoir. They also keep the system at...