dicktill's latest activity

Yes, but in the opposite order: loader, backhoe, then 3-point. Have you looked at: How Massey Ferguson GC 1723 & 1725 hydraulics are...

Most CUT tractors have two or three range gear type transmission behind the HST. In low range the HST should spin tires same as geared...

As always you are correct, it is a priority flow control, although the factory service manual calls it "flow dividing valve". The...

Is it a flow divider or priority flow control valve? Flow divider divides the flow in a fixed proportion regardless of inlet flow...

Ouch!

first post shows picture of hole in block...

Sorry to hear your Fergie’s laid up. Always tough when the old workhorse is down. What’s the issue—engine, hydraulics, or something...

I had a gearbox come apart on my batwing that was replaced under warrantee. The question that I was asked over and over again was if...

The only way I could see them denying a claim, is if they found no oil in it! Otherwise ... It's not "operator/owner" error, but they...

No word yet, but I'll contact them later today. I think they will have to at least remove the oil pan to look at the debris and try to...

I sure wouldn't, if it was my dealership. Beside simple curiosity about the failure mode, there is no incentive to spend time paying...

Any more info from the dealer who's tearing the engine down? They actually might not spend any time tearing it down, and just replace...

quote from I do cars presenter: "...after market inspection port"... when refering to holes in the block. I to have had a big end...

My first thought is that the dividing valve is not working.

The rear PTO (540 rpm) is at 2532 rpm on mine versus 2829 on yours. The mid PTO (2000 rpm although the service manual [page 1-29]...