dicktill's latest activity

Good point. But I'd also be pissed if I had a hole in my block. Might need to at least get toe on the line 😁

Around here in the spring and fall a traffic jam is two tractors or combines meeting on the township or county roads. Combines with...

The dealership is 30-miles/45-minutes away. Yes, sometimes "the squeaky wheel gets the grease", but it can also piss them off if...

@kennyd: you're "boring" : )

I suspect they'll need some prodding and pestering before this is completed. I think I'd be calling and/or visiting in person if not to...

may have poked camera in to take pic of rod ends to send to warranty dept. prob can't touch it much until they get the go ahead.

That should have been easy with the holes in the block :LOL::LOL:

I'd like to give you a nice update on this but we're not getting anywhere with this so far. The mechanic "started diagnosing" it last...

Not exactly a true flow meter, but if you use the "hose into a bucket" method with some sort of an orifice (or a nearly closed valve)...

Oh please, that plant withstood more than probably any other place in the universe. The safety controls did an automatic shutdown when...

Because the edit function isn't friendly, here is a new post based on my personal experiences with both Hydro and geared Shuttle...

Okay, sorry, I stand corrected! I was going by / confused by the fact that Prince representatives were adamant that I couldn't' have...

OP wants to INSTALL edging, presume either plastic or metal ... Cut a slice in the ground, drop edging in, tamp down/close the cut soil...

This post is for any who follow with the same or similar controls on a similar tractor which is basically any tractor with a loader and...

Correct there is no free lunch. But the sun and wind are lots cheaper than coal and oil once the infrastructure is in place. These...