Recent content by Brady D

My ford 1910 like many old tractors turns over rather slowly when cranking. So I was wondering if I replaced the solenoid if it would make it any faster or does the whole starter need to be replaced? Also if a solenoid would make a difference what size and type would I need? Thanks for any help.

Does anyone know of a spin on fuel filter adapter for a ford 1910?

I was a little concerned how to modern loader would look on it, however she sits just right.

Got my westendorf ta-111A installed on my 1986 ford 1910. Pretty pleased with it.

Does anyone know where I can get a replacement shifter knob for my ford 1910? SBA398180210 Is the part number. I already purchased two from wengers however only one came in the mail and it was in fact not the knob they had listed. Any help is appreciated.

I didn’t realize it had a vent

Accident avoided

Is the bolt that I have circled a oil drain for one of these old Kiki diesel injection pumps?

When changing fluids in my ford 1910 does the rear diff have different fluid from the transmission or is it all from the same tank?

I have a ford 1910 with a leaking injection line at the fitting going to the injector, and I’m in need of a replacement. Where could I find one? Part number SBA131506720

I’ve been trying to install a new westendorf loader on my ford 1910 however I can only get the psi above 200 on the diverter block when I put the 3 point hitch lever all the way to the top in the notch area, however once in the notched area the psi will be at 2000. Does anyone have any...

When you say loosen it do you mean to completely loosen or just back it off a few turns?

That’s what I figured

Definitely is better. the original oil in it had some water contamination.

I’ve recently changed my hydraulic fluid and used Delvac tractor fluid however I’m now concerned it may be bad since it is not new holland brand. Has anyone used it or have any knowledge? I used it in my 1986 ford 1910.