Recent content by bodin1968

if you care about preserving the equipment and its leaking have the bottom seal repaired. most manufacturers recommend 75/90 not cornhead grease.

John Deere GL-5 75/90 Synthetic Gear Lube TY26375 in my MX6

is this whine only when the tractor is in 4WD? has this only been noticed on the M4s, and not on the 7060s? looking at both tractors but I liked the (rear remote, bigger cab & front tires, E-PTO) upgrades on the M4s

Been a fairly wet and cooler summer down south in 2021

following.....

my next tractor will have a cab, loader and 4WD. no exceptions. TN gets cold and hot, and it rains. get the cab

End of fuel line that must be connected to f. Injector pump looks just like this banjo fitting. Hollow screw above would go thru that opening.

2020 JD Tractor. I replaced the front metal fuel line (top of the line was leaking) 1. my (leaking) issue is where the fuel line (hollow screw- see pic below) screws into the fuel injection pump. [i'm dealing with f. line that's behind the pump that's about impossible to get to]. there are...

good advice but no that is an older pic and not my trailer etc... another pic.....

ok try these.......

help... anyone know the approx. weight of a 1968 JD 2020 FEL?? thanks (50 yr. old manual says tractor total weight for this 2020 (without FEL) is 4,930 lbs. see pic in profile to left....

LMC AG Sprayer 85 or 110 gallon. anyone have experience w/ this company's equip. outta GA or their sprayers? tx

want a good fert/seed spreader that is QH compatible... JD dealer says this one will work w/ QH... anyone have experience w this Frontier spreader? TX

recently changed all of the fluids on the 2020 (hydraulic oil/filter, engine oil/filter, coolant etc.).... i'm having no hydraulic issues w tractor. should i pull this hyd. pump filter and clean it or leave it alone? thanks in advance....

i added this ratchet strap. at hook up it placed top link connection right where i needed it. problem solved... after hook up w/ the QH i take it off. thanks for the help....