Recent content by BobQ

So I'm looking for a lager bucket for my loader, it does not have a quick change mount, any ideas on what size and where to get it?, I move around a lot of dirt and think I can lift and move more than this stock one will allow. Anyway, any help would be great! Thanks Bob

So, I need to replace the seal on the boom cylinder for my 9620 back hoe. I need the wrench/tool that fits into the two pin holes and unscrews the cap for the hydraulic cylinder, would any one know where to get one? or maybe even a part number? Thanks for any help you can offer. Bob

I have been busy with work and not around much, here is a septic that the 4720 is doing, it is a small property and no where to put material, the loader is worth its weight in gold on this one! here is a pic of the tank, nine feet deep, and one galley, the second is just being started.

I have a 4720 with a branding loader, is it possible to get a joy stick control for the loader and where can I get it?

I am wondering if any one has seen a solution to keeping the 3pt hitch arms on with the frame mount back hoe? My back hoe uses the same attachment points as the lower arms. Thanks Bob

I need blades for a Jinma Chipper, anyone know where I can get them? also is there a set from another chipper with a little bit better quality that would fit? the originals seam to crack easily. Thanks Bob

I have a 4720 with a BL20a loader. I am wondering if there is a bigger bucket available or any other options? I would like to be able to move lighter material a little faster. Thanks Bob

I have an 18' equipment trailer and want to use it to move some process and stone, anyone ever try this and how did it work? I am thinking I will put some sides up and use my loader to unload it? any help would be apprecialed! I had to sell the dump:( Thanks Bob

I am looking for a new trailer for my 4720 TLB, I am wondering what weight and length I need? I want an equipment type that goes on my hitch. I am thinking a 10,000GVW and not too sure on length? Maybe 16 or 18 foot? Any help would be appreciated. Bob

I went to napa to get the adapter so I can load my tires, and they can't find what I am talking about, does any one know the part num, or the proper name to call it, so they can find it? Thanks Bob

I have a Jinma Chipper and want to set it up with an older tractor that does not have a three point hitch. I am looking for a good way to secure the chipper for use? It does have to be somewhat movable, in other words no concrete, and not a day each time I move it. I plan on running it with...

I understand how a open center valve works, but how does a closed center valve work? What would the aplication be? Thanks Bob

Here are a set of forks I made for the FEL. They are a little different then the other ones I have seen. I have also stalled them with wieght and no break or bend so far! I mostly made them from scrap I had laying around.

Here is a top link extender I made for use with my pats ezchange. I love the ezchange by the way. Some times the top link was just too short.

I know that there is a relief valve on the loader spool valve, and somewhere on the backhoe spool valve, but what about the 3point hitch? also, I have a 3pt log splitter and don't see a relief valve on that spool valve? Is there a relief valve somewhere else in the system? and if so, what...