Recent content by Blondie70

My old Cub tractor had a grease fitting for the throwout also.

I got my seat unstuck...took it apart and had to beat the frame with a big hammer. Ended up removing one spring and the adjustment bolt. Used an eye bolt instead..so could pull tension from the middle of the adjuster. Lots of penetrating oil, motor oil and hammer got it all thawed out. I am a...

I am finding the spring adjustment for my seats is frozen up. Frozen up as like welded up. Cannot get it to loosen up. This thing has some BIG heavy springs for the seat. I guess it has been like this from new. Finally realized the adjustment info in the manual is a joke. Nothing happens no...

I think they are "Assembled in the USA" !

Try e bay.

Thanks Chewwy !!!!!

I have one of those. Same thing but no third function...I don't recognize where this is...so I guess it is associated with third function ??

Anyone know of anyone that has paid such fines....or any fines for that matter ?

Howdy ....I have a 2501 with a backhoe and loader. Where is a good place to install a pressure gauge ? Would the location cover pressures on both ? Thanks for any info......Pete

Will it go down with engine off ?

Thanks Ed. I appreciate it !!! Pete

Can anyone tell me the correct oil filter for this tractor ? Thanks

Thank You Lens. It is running really good with press at 50 psi. Thanks for your insight. Pete

Thanks for the reply, Roadworthy. I have a manual gauge installed. Removed it and verified it was OK. I ran tractor today at length the pressure remained high, but did drop a little when hot. I reckon it is something internal or maybe something got cleaned up and the pressure is normal now ...

Howdy. My old 2 cyl 1600 I just bought normally runs around 25 psi oil pressure at 1500 rpm. Something happened and the pressure went to around 55 at 1500 rpm. The pressure is staying up as long as I run the engine...drops some at lower rpm. I had flushed the engine with a couple changes and a...