Recent content by airlynch

It's my big weekend project. I expect a 42% torque increase on the back end of the curve. Will post the reports after the dyno sesh. ;-)

I think I found it, maybe ..... To reset a Kioti DK Series tractor's HST (Hydrostatic Transmission), you'll need to ensure the tractor is in neutral, the engine is off, and the brake is engaged, then turn the key to the "on" position, wait for the dash lights to cycle, and then turn the key...

Shop manual has a reset sequence for HST that I am looking for.

Hello Could someone post the DK series reset sequence for HST range selections? I believe it is in the shop manual. Thanks

Thanks all. Much appreciated. I am back up and running.

Thanks all. Bloodyrun where would you place a weld?

I think the pin may have just sheared from selector to shaft. Parts diagram shows two spring pins ...I want to just put a nail through it. :-)

My tractor has 240hrs and would only work in M range or N. Today it stopped grabbing M and is in neutral even when dash shows H-M-L-N based on selector (i.e shifter). I have a service manual on the way, but would welcome any guidance you all may share.

Okay maybe a stupid question but do you all wash your tractor? If so what do you use? garden hose and bucket with soap Powerwasher? So far I have just been using compressed air, but have been thinking of doing a good cleaning before the snow flies and just a bit nervous about getting water...

Thanks everyone for the help. I was able to figure it out after some trial and error. I am dead tired but was able to put up a lot of wood today. Thanks again for all the help and that is not only on this issue, but I relied on your posts as a vital part in my decision on buying the Kioti...

Hello first post. Bought a 2013 DK45 HST this summer (26 hrs so far so good). I just purchased and put together a 3pt log splitter and need to buy hoses and fittings. I think the rear remotes are 1/2" but not sure what other spec to reference for the male quick connections. A few questions I...