LS Tractor Owner
Super Member
- Joined
- May 1, 2017
- Messages
- 7,562
- Location
- Edgewood, NM
- Tractor
- LS XG3025 TLB, Previously MT125 TLB, Craftsman GTS6500
Good morning to all! No rain overnight, slight chances of a passing T-storm today. Temps up to the low 90's.
Not sure what will be on the agenda today.... maybe a little cleanup where the tanks were sitting, some weedwacking may be in order. I know there is a steel barrel out there that I have been meaning to cut open to make a burn barrel.... maybe get to that.
I cannot get too involved in anything, today is the 37th trip around the sun with my bride and soulmate! We really don't have any plans, but I still will stick close to home base today.... at least I am still smart...
PJ, let me know how the $100 plan works out....
Drew, be careful crawling around on the ground... don't mess up the neck any more than necessary...
Rng, it it a tough call to decide.... could have used both equally over last year... but, the plasma cutter will be used almost immediately to make 2 implements for the tractor... a land plane and a rear grader blade. Then they will almost need the T&T immediately when they get put to use....So what comes first, I guess the plasma cutter so the implements can be MADE. The T&T will be more for convenience....
Kyle, I forget to mention that I was glad to hear about your daughter playing / singing at church.
Wifey just asked if I could make a run down to Costco..... can I say no....?? Funny how it works...
Everyone have a great day!
Not sure what will be on the agenda today.... maybe a little cleanup where the tanks were sitting, some weedwacking may be in order. I know there is a steel barrel out there that I have been meaning to cut open to make a burn barrel.... maybe get to that.
I cannot get too involved in anything, today is the 37th trip around the sun with my bride and soulmate! We really don't have any plans, but I still will stick close to home base today.... at least I am still smart...
PJ, let me know how the $100 plan works out....
Drew, be careful crawling around on the ground... don't mess up the neck any more than necessary...
Rng, it it a tough call to decide.... could have used both equally over last year... but, the plasma cutter will be used almost immediately to make 2 implements for the tractor... a land plane and a rear grader blade. Then they will almost need the T&T immediately when they get put to use....So what comes first, I guess the plasma cutter so the implements can be MADE. The T&T will be more for convenience....
Kyle, I forget to mention that I was glad to hear about your daughter playing / singing at church.
Wifey just asked if I could make a run down to Costco..... can I say no....?? Funny how it works...
Everyone have a great day!